Search: Posts Made By: qkvette
Showing results 1 to 25 of 292
Search took 1.46 seconds.
06-13-2005, 05:13 PM
Replies: 186
Views: 17,210
Posted By qkvette

I wish I was on the list. I think 65K is a good...

I wish I was on the list. I think 65K is a good price for what you are getting. The car is an out of the box race car. For those that are on the list and getting this beast, please let us know,...
05-24-2005, 01:52 PM
Replies: 10
Views: 3,430
Posted By qkvette

Thank you all for the reply. I checked it last...

Thank you all for the reply. I checked it last night and it is the solenoid. There is about a 6 inch wire attached to the unit, located on the passenger side, that you can pull and release the...
05-23-2005, 06:09 PM
05-23-2005, 01:54 PM
Replies: 10
Views: 3,430
Posted By qkvette

thanks. i'll take a look tonight.

thanks. i'll take a look tonight.
05-23-2005, 01:39 PM
Replies: 10
Views: 3,430
Posted By qkvette

Rear hatch solenoid failed -- how do you manually open the hatch?

how do you manually open the rear hatch once the solenoid fails ??

thanks,

Joel
01-21-2005, 04:36 PM
Replies: 36
Views: 1,280
Posted By qkvette

I had similar problems with my mustang (v6 daily...

I had similar problems with my mustang (v6 daily driver) after it overheated once, and the culprit was a bad head gasket. the water in the system would actually run very low and it only overheated...
01-21-2005, 01:40 PM
Replies: 8
Views: 397
Posted By qkvette

i have these same injectors on my 92. use the...

i have these same injectors on my 92. use the top slot. i' ve had them on for the past 2 years and no problem. hope this helps.

joel
12-30-2004, 01:59 PM
Replies: 83
Views: 7,168
Posted By qkvette

:iagree: I was hoping low 60s. That would make...

:iagree: I was hoping low 60s. That would make it the best car for the buck. At 75k, that pretty much puts it out of my reach. :(
10-20-2004, 02:42 PM
Replies: 7
Views: 357
Posted By qkvette

Thanks, I will check these out.. Joel

Thanks,

I will check these out..

Joel
10-20-2004, 01:41 PM
Replies: 7
Views: 357
Posted By qkvette

Need help on brother's 86

I hope someone can chime in with a solution. By brother's 86, recently started stalling when you put it in gear (R or D) when the car is warm. The car has a hotcam and 2400 stall converter. It...
09-29-2004, 07:24 PM
Replies: 6
Views: 414
Posted By qkvette

i did an engine swap on my car after i threw out...

i did an engine swap on my car after i threw out a rod bearing. i think engine installation around $800, a crate motor from sdpc (scoggin dickey :12498772 ZZ383/425 425 HP 383 Small Block Crate...
09-28-2004, 02:17 PM
Replies: 4
Views: 407
Posted By qkvette

Just went to my first corvette show

I went to my first corvette show this weekend in Thousand Oaks, CA put toghether by Redline Corvettes, and it was a fun experience.

It is a cool site to see so many vettes from different years...
09-01-2004, 06:14 PM
Replies: 22
Views: 1,114
Posted By qkvette

You may want to put a tranny cooler. I also have...

You may want to put a tranny cooler. I also have 3.73s on mine and I used to have a 2800RPM stall converter w/o a tranny cooler, before I blew up my tranny. I went back to a 2400 stall, to reduce...
08-16-2004, 01:19 PM
Replies: 15
Views: 5,461
Posted By qkvette

i have a 383 LT4 motor in my 92 w/ hot cam. it...

i have a 383 LT4 motor in my 92 w/ hot cam. it passes smog with no problems. i think as long as you have the smog equipment on the vehicle, you should be okay. good luck and welcome to california....
08-13-2004, 05:15 PM
Replies: 3
Views: 378
Posted By qkvette

i didn't buy the electric plates from mccord yet....

i didn't buy the electric plates from mccord yet. i think i can live this sound. i'll try to record the sound. i used to have the flowmaster system on my car w/o cats, and it is a little bit...
08-13-2004, 02:54 PM
Replies: 3
Views: 378
Posted By qkvette

cut outs are in !!

I just the cut outs installed behind the resonator a couple of days ago, and it sounds great. There is alot of resonance at 2000rpm around 60 mph( have 3.73s), but around 70 mph it is okay. i'm not...
07-30-2004, 01:50 PM
Replies: 2
Views: 249
Posted By qkvette

Getting my car back today or tomorrow

After finding out the total cost of a tranny conversion, I decided to stick with the auto and have it rebuilt. this time they are putting the 5 pinion planetary gears, a tranny cooler, and other...
07-23-2004, 05:30 PM
Replies: 10
Views: 1,027
Posted By qkvette

Good idea ... Where did you put the AMP ?? ...

Good idea ...
Where did you put the AMP ??

Thanks,

Joel
07-15-2004, 06:16 PM
Replies: 44
Views: 1,921
Posted By qkvette

using stock LT1 head flow the numbers are : ...

using stock LT1 head flow the numbers are :

408hp@5000 and 462@3500-4000
07-15-2004, 05:46 PM
Replies: 44
Views: 1,921
Posted By qkvette

If you can post your airflow, i can plug the...

If you can post your airflow, i can plug the numbers in on desktop dyno, so you can atleast have some idea on theoretical figures. i run a simulation with your cam specs using lt4 head flow numbers...
07-02-2004, 05:04 PM
Replies: 0
Views: 242
Posted By qkvette

anyone got pics of mccord power plate on their C4 ?

how's the sound ?

any hp gain ??

thanks,

joel (happy 4th of july)
07-01-2004, 08:31 PM
Replies: 4
Views: 564
Posted By qkvette

anyone have pic of a red 92-96 C4 w/ black GS rims ?

Well, Since I'm no longer attempting to do the swap ($5k), I will have my tranny rebuilt, and with the money I save, I may try to have the car repainted. Choosing from either Tocrh Red, White w/...
06-28-2004, 03:32 PM
Replies: 0
Views: 223
Posted By qkvette

Anyone that went to bloomington, saw the Keisler booth ?

Just wondering if anybody saw the C4 T56 conversion.

Thanks,

Joel
Showing results 1 to 25 of 292
 


 
Forum Jump


All times are GMT -4. The time now is 10:09 AM.