CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: MrEracer
Showing results 1 to 25 of 497
Search took 1.70 seconds.
Forum: C5 Tech
11-22-2017, 10:07 AM
Replies: 9
Views: 1,688
Posted By MrEracer

You might take a look at the switch under the...

You might take a look at the switch under the clutch. I think the purple wire comes from this switch. You must have the clutch all the way down to enable starting. Either you are not pushing the...
Forum: C5 Tech
10-30-2017, 10:23 AM
Replies: 5
Views: 1,736
Posted By MrEracer

Have you had the fuel pump removed recently? I...

Have you had the fuel pump removed recently? I had the same problem when the sock on the pump was folded up during re-installation causing it to suck air at low fuel levels...
MrE
Forum: C5 Tech
10-21-2017, 10:10 PM
Replies: 23
Views: 5,621
Posted By MrEracer

There is a ground stud with a single wire on the...

There is a ground stud with a single wire on the left rear of the frame behind the left rear wheel. If this ground is loose or corroded the car will not start. Check it out.
Shirl Dickey
Forum: C5 Parts for Sale/Wanted
10-04-2017, 09:46 AM
Replies: 8
Views: 861
Posted By MrEracer

Diff has been sold... MrE

Diff has been sold...
MrE
Forum: C5 Parts for Sale/Wanted
10-03-2017, 09:16 PM
Replies: 8
Views: 861
Posted By MrEracer

It's all C5. Rear ends are not that complex, ...

It's all C5. Rear ends are not that complex, much simpler than a T56.
Shirl
Forum: C5 Parts for Sale/Wanted
10-02-2017, 02:01 PM
Replies: 8
Views: 861
Posted By MrEracer

OBO Bump

OBO Bump
Forum: C5 Parts for Sale/Wanted
10-02-2017, 11:49 AM
Replies: 2
Views: 323
Posted By MrEracer

I have an A4 torque tube to trans wiring harness....

I have an A4 torque tube to trans wiring harness. Not sure what year it is. $110 shipped.
MrE
Forum: C5 Parts for Sale/Wanted
10-02-2017, 11:44 AM
Replies: 1
Views: 332
Posted By MrEracer

I have a used BW, filter only. Fits all C5's. ...

I have a used BW, filter only. Fits all C5's. $80 shipped.
MrE
Forum: C5 Parts for Sale/Wanted
10-02-2017, 11:41 AM
Replies: 3
Views: 619
Posted By MrEracer

I have a rebuilt 3.42 diff listed in this forum...

I have a rebuilt 3.42 diff listed in this forum if you still need one.
MrE
Forum: C5 Parts for Sale/Wanted
10-01-2017, 10:23 AM
Replies: 8
Views: 861
Posted By MrEracer

Bump

Bump
Forum: C5 Parts for Sale/Wanted
10-01-2017, 10:20 AM
Replies: 2,139
Views: 167,459
Posted By MrEracer

Looking for right and left front inner fender...

Looking for right and left front inner fender wells (large fiberglass parts). Damaged but repairable is okay.
MrE
Forum: C5 Parts for Sale/Wanted
09-30-2017, 09:28 AM
Replies: 8
Views: 861
Posted By MrEracer

Rebuilt Z06 Diff

C5 Z06 3-rib, 3.42 reconditioned diff with new posi clutches and seals. Gears and bearings inspected and in excellent condition. I have over $300 in parts receipts. Pic's available. $750 shipped....
Forum: C5 Parts for Sale/Wanted
09-29-2017, 11:39 AM
Replies: 7
WTB: C5 top
Views: 871
Posted By MrEracer

I have a solid top, yellow, complete and in good...

I have a solid top, yellow, complete and in good condition. Headliner sags and needs re gluing, very minor paint cracks on right rear corner,easily repaired when painting. $450 OBO plus shipping....
Forum: Autocrossing & Roadracing Classifieds
04-24-2013, 09:57 AM
Replies: 20
Views: 1,791
Posted By MrEracer

Wish you were closer, I've repaired more than 20...

Wish you were closer, I've repaired more than 20 cars just like that. I'm looking for a good torque tube assy if you have one.
Shirl Dickey
Aguila, AZ
Forum: C5 Parts for Sale/Wanted
12-31-2012, 12:40 AM
Replies: 4
Views: 338
Posted By MrEracer

I have one I will put in a flat rate box for you....

I have one I will put in a flat rate box for you. $5 shipped.
MrE
Forum: C5 Parts for Sale/Wanted
12-26-2012, 12:43 PM
Replies: 0
Views: 528
Posted By MrEracer

Mod'ed C5 LS1 Engine For Sale

I have a mildly built LS1 engine for sale. It has Katech CNC heads, GTP 420 cam (.226/.226 - .595/.595 on 112 lsa), trick flow push rods, dual valve springs with Ti retainers, ported oil pump, a Z06...
Forum: C5 Parts for Sale/Wanted
12-25-2012, 06:29 PM
Replies: 2
Views: 542
Posted By MrEracer

I have an LG 'G5XE' cam in like new condition...

I have an LG 'G5XE' cam in like new condition (less than 2000 miles). Specs per Cam Dr are: 231/236 duration, .588/.600 lift on 111 lsa. $250 plus shipping.
MrE
Forum: C6 Parts for Sale/Wanted
08-08-2011, 10:03 AM
Replies: 5
Views: 356
Posted By MrEracer

Bump

Bump
Forum: C6 Parts for Sale/Wanted
08-07-2011, 07:16 PM
Replies: 5
Views: 356
Posted By MrEracer

I need 8 valves. I don't mind buying from...

I need 8 valves. I don't mind buying from different sources to get 8 valves. Let me know what you have and your price.
MrE
Forum: C6 Parts for Sale/Wanted
08-07-2011, 04:22 PM
Replies: 48
Views: 2,597
Posted By MrEracer

Any chance that you have a set of LS7 Ti intake...

Any chance that you have a set of LS7 Ti intake valves, new or used...
MrE
Forum: C6 Parts for Sale/Wanted
08-07-2011, 04:17 PM
Replies: 5
Views: 356
Posted By MrEracer

WTB - LS7 Ti Intake Valves

New or used, let me know what you have...
MrE
Forum: C5 Parts for Sale/Wanted
02-23-2011, 11:00 AM
Replies: 157
Views: 6,656
Posted By MrEracer

Do you have the ABS module (located in front of...

Do you have the ABS module (located in front of the power steering pump and alternator)? If so, how much?
Thx
MrE
Forum: C5 Tech
10-08-2010, 08:31 PM
Replies: 46
Views: 4,533
Posted By MrEracer

The generic radiators I have used require the...

The generic radiators I have used require the lower right side port to be revised because it must clear the sway bar. This usually requires that it be directed upwards. Also, the port diameter is...
Forum: C5 Tech
10-08-2010, 03:22 PM
Replies: 46
Views: 4,533
Posted By MrEracer

I have used these radiators for road race cars. ...

I have used these radiators for road race cars. You may find 31" a little wide to fit. I use genaric radiators that are about 28" wide. I always revise the inlet/outlet ports and also weld up the...
Forum: C5 Tech
10-08-2010, 02:45 PM
Replies: 1
Views: 1,762
Posted By MrEracer

A4 Shifting Problem - DTC 1810

2001 A4 will not shift into 4th gear. DTC 1810 set. This calls for replacement of the TFP switch (Trans fluid pressure switch). My question is; can this switch be replaced while on the car or does...
Showing results 1 to 25 of 497
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 04:55 AM.