Search: Posts Made By: easyasone2three
Showing results 1 to 25 of 238
Search took 1.75 seconds.
Forum: C3 General
12-29-2010, 11:57 PM
Forum: C5 Tech
02-16-2009, 03:03 PM
Replies: 2
Views: 820
Posted By easyasone2three

I recently had the "low oil level" warning that...

I recently had the "low oil level" warning that kept coming on and the oil was full and pressure was good. Turned out that the wire to the oil level sensor had burned on the header and was shorting...
Forum: C5 Tech
02-13-2009, 11:56 PM
Replies: 5
Views: 634
Posted By easyasone2three

Replace the hazzard switch. Just do this:...

Replace the hazzard switch.

Just do this: http://myweb.cableone.net/kd5fx/HSwitch/HSwitch.htm
Forum: C5 Tech
01-13-2009, 07:59 PM
Replies: 15
Views: 14,096
Posted By easyasone2three

Final 18 ft lbs. Of course, recheck a couple of...

Final 18 ft lbs. Of course, recheck a couple of times after a few heat cycles.
12-28-2008, 05:12 PM
Replies: 2
Views: 513
Posted By easyasone2three

There are no error messages and it does it with...

There are no error messages and it does it with all disks.
12-26-2008, 09:20 PM
Replies: 2
Views: 513
Posted By easyasone2three

My Clarion won't take a CD

I have had my Clarion DXZ865MP for 2 years and in the last week or so it just rejects every CD I load into it. It gives no indication what the problem is, just rejects the disk.
Forum: C5 Tech
11-19-2008, 02:37 PM
Replies: 3
Views: 8,848
Posted By easyasone2three

Thanks. I don't know what I was thinking, I...

Thanks.

I don't know what I was thinking, I sould have fixed the wiring when I had the header loose and the starter out last week.

I was under there with a light and mirror and I think I see...
Forum: C5 Tech
11-18-2008, 08:42 PM
Replies: 3
Views: 8,848
Posted By easyasone2three

How to Remove Connector from Oil Level Sensor?

What is the trick?

My header burned the wires. I replaced the starter last week and apparently moving the burned wires around has caused a short and the "Low Oil Level" keeps comming up. If I get...
Forum: C5 Tech
11-11-2008, 12:44 AM
Replies: 17
Views: 304
Posted By easyasone2three

Yep. Was just going to replace the solenoid but I...

Yep. Was just going to replace the solenoid but I have headers and the passenger side had to be unbolted to get to the starter. Since I had to do all that I just had the starter rebuilt at the local...
Forum: C5 Tech
11-09-2008, 09:32 PM
Replies: 22
Views: 8,310
Posted By easyasone2three

To change the starter you have to unbolt the...

To change the starter you have to unbolt the passenger header. Just did it today and it took a few extra hours.

Overall though the headers are well worth it.
Forum: C5 Tech
11-05-2008, 07:02 PM
Replies: 13
Views: 305
Posted By easyasone2three

Add some long tube headers and it will make a...

Add some long tube headers and it will make a real nice difference.
Forum: C5 Tech
11-05-2008, 06:52 PM
Replies: 17
Views: 304
Posted By easyasone2three

Don't want to hijack but I have the same problem....

Don't want to hijack but I have the same problem.

Couple of weeks ago I turned the key and no start. Key off then back on and the car started - happened twice.

Yesterday I got in to go to work...
Forum: C5 Tech
10-24-2008, 12:38 PM
Replies: 20
Views: 829
Posted By easyasone2three

I put on American Racing long tube headers, x...

I put on American Racing long tube headers, x pipe and cats and had the car dyno tuned and it really did make a big difference in power. It was pretty expensive though.
Forum: C5 Tech
10-23-2008, 04:45 PM
Replies: 20
Views: 829
Posted By easyasone2three

I have long tube headers and have had mine smoged...

I have long tube headers and have had mine smoged twice at two different stations without any problem at all. 15 minutes, $40 and gone. I even was at a third location with no questions and their...
08-07-2008, 12:49 AM
Replies: 22
Views: 2,311
Posted By easyasone2three

I don't know but it seems like the Florida and...

I don't know but it seems like the Florida and Texas guys are out of line pretty often.
07-20-2008, 10:09 PM
07-19-2008, 07:52 PM
Replies: 34
Views: 1,396
Posted By easyasone2three

Put in the LUK clutch yesterday and problem...

Put in the LUK clutch yesterday and problem solved. No vibration at all - in fact I had vibration all through the RPM range that I didn't even realize, but it was worst at hard acceleration.

I am...
07-19-2008, 01:40 AM
Replies: 11
Views: 726
Posted By easyasone2three

Put the new LUK clutch in today and drove it the...

Put the new LUK clutch in today and drove it the 40 miles home. No vibration at all - problem solved. I don't recommend Centerforce for these cars.
07-14-2008, 06:09 PM
Replies: 11
Views: 726
Posted By easyasone2three

I just put a Centerforce 1 clutch and pressure...

I just put a Centerforce 1 clutch and pressure plate in my 72 454 and now jave a bad vibration between 3-5000 rpm. Steering wheel vibrates. Flywheel was resurfaced, driveshaft balanced, new u-joints...
06-14-2008, 09:25 PM
Replies: 10
Views: 650
Posted By easyasone2three

If you are talking about the air you can see in...

If you are talking about the air you can see in the clear Motive line between the Motive tank and your mastercylinder - don't worry about it, the brake fluid flows past and the air in the line won't...
Forum: C5 Tech
06-14-2008, 01:38 AM
Replies: 3
Views: 477
Posted By easyasone2three

Unsprung Weight-C5 Z06 Wheels

I know that there has been discussion about this so here goes.

My stock wagonwheels were in bad shape on my 01 - my car spent it's first couple of years in Pennsylvania with the snow and salt.
...
06-09-2008, 12:54 PM
Replies: 17
Views: 515
Posted By easyasone2three

I have an 01 with long tube headers and have...

I have an 01 with long tube headers and have passed smog no problem 2 times first try at two different shops. The headers and a tune really make the car run better.
05-29-2008, 05:33 PM
Replies: 15
Views: 732
Posted By easyasone2three

Nice looking car. Call the salesman and have him...

Nice looking car. Call the salesman and have him give you the VIN# from drivers window pillar and then the numbers stamped on the engine block pad on the passenger side just below the head and above...
04-27-2008, 10:41 PM
Replies: 7
Views: 469
Posted By easyasone2three

I have an almost new 7 leaf you can have if you...

I have an almost new 7 leaf you can have if you pay shipping.
04-25-2008, 03:45 PM
Replies: 3
Views: 435
Posted By easyasone2three

Try calling John at gmdownunder.com I think...

Try calling John at gmdownunder.com I think he ships/sells Corvettes there and should be able to give you some answers.
Showing results 1 to 25 of 238
 


 
Forum Jump


All times are GMT -4. The time now is 12:30 PM.