CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 18
1
2
3
11
Last »
Search: Posts Made By: paz
Showing results 1 to 25 of 428
Search took 1.68 seconds.
Forum: C6 Corvette General Discussion
10-14-2013, 09:22 PM
Replies: 12
Views: 4,512
Posted By paz

Thanks Bill, Is taking out the seat as...

Thanks Bill,

Is taking out the seat as simple as undoing 4 nuts?
Forum: C6 Corvette General Discussion
10-11-2013, 01:56 PM
Replies: 12
Views: 4,512
Posted By paz

Small fuse box installed upside down

Here's a pic of my passenger side fuse layout. You can see the small fuse box was installed rotated 180 degrees. This made finding the right fuse a little confusing at first. I replaced the blown...
Forum: C6 Corvette General Discussion
10-10-2013, 06:15 PM
Replies: 12
Views: 4,512
Posted By paz

Incorrect fuse diagram: Lumbar, bolster, seat heater all the same fuse

Thanks guys, it was a fuse. BUT there is still some info worth telling.

My passenger side fuse box is wired differently than the fuse diagram and manual. The position labeled PWR LUMBAR is not...
Forum: C6 Corvette General Discussion
10-10-2013, 05:47 PM
Replies: 12
Views: 4,512
Posted By paz

I keep my seat down as far as it will go for...

I keep my seat down as far as it will go for extra head room too!
I'll check the fuse! My seat heater stopped working too. I don't turn the heater on very often here in Texas. I'm going to check...
Forum: C6 Corvette General Discussion
10-09-2013, 04:59 PM
Replies: 12
Views: 4,512
Posted By paz

I had a look. A tight space with a lot of wires!...

I had a look. A tight space with a lot of wires! Should I remove the seat for a better look? Is it easy to remove/replace a seat?

I did find my lost sunglasses.
Forum: C6 Corvette General Discussion
10-09-2013, 04:44 PM
Replies: 12
Views: 4,512
Posted By paz

Thanks. Yes, I have experience other seat...

Thanks. Yes, I have experience other seat problems. My seat settings recall messes up a lot of the time and my air bag light flashes red sometimes. I'll check my connectors. What am I looking for?
...
Forum: C6 Corvette General Discussion
10-09-2013, 11:52 AM
Replies: 12
Views: 4,512
Posted By paz

Bolster and lumbar pump not working - fuse/relay?

My driver side bolster and lumbar pump is not working. The passenger side works and I can hear the pump. The driver side makes no noise when the switches are pressed. I'm guessing the problem is...
Forum: C6 Corvette General Discussion
07-17-2013, 01:30 PM
Replies: 8
Views: 1,211
Posted By paz

Simpler way to re-attach the bow pin

I found a simpler way to re-attach the bow pin. In the first picture (attached), you can see my arm reaching into the roof. From this access I could easily reach the top of the pin and snap the clip...
Forum: C6 Corvette General Discussion
07-17-2013, 01:21 PM
Replies: 29
Views: 2,533
Posted By paz

Simpler way to re-attach bow pin

I found a simpler way to re-attach the bow pin. In the first picture (attached), you can see my arm reaching into the roof. From this access I could easily reach the top of the pin and snap the clip...
Forum: C6 Corvette General Discussion
07-16-2013, 05:09 PM
Replies: 8
Views: 1,211
Posted By paz

Thanks a million! Good to hear it is an easy...

Thanks a million!
Good to hear it is an easy fix. I was worried the cloth may not go back the way it was, but sounds like that is not an issue. I may put a dab of epoxy on the pin and retainer to...
Forum: C6 Corvette General Discussion
07-16-2013, 03:10 PM
Replies: 8
Views: 1,211
Posted By paz

Yes, I was hoping it would be that easy. I tried...

Yes, I was hoping it would be that easy. I tried pushing it back in, but there is no resistance at all.
Forum: C6 Corvette General Discussion
07-16-2013, 11:41 AM
Replies: 8
Views: 1,211
Posted By paz

C6 convertible bow pin fell out

The left convertible top bow pin just fell out of the top the other day.
How complicated is it to re-install the pin?
It looks like it was held in by a snap ring.
Is there a procedure to follow...
Forum: C6 Corvette General Discussion
04-06-2013, 10:44 AM
Replies: 7
Views: 600
Posted By paz

Thanks Bob, You're right there is a lot of...

Thanks Bob, You're right there is a lot of different info out there. I think the most important bit of info is that the nuts are ONE-time use only. They deform to mate with the hub. Re-tightening the...
Forum: C6 Corvette General Discussion
04-05-2013, 05:49 PM
Replies: 7
Views: 600
Posted By paz

OK, I deserve the wagging finger! I didn't look...

OK, I deserve the wagging finger! I didn't look under the covers. In my defense, my car is in a tight space in the garage and blocked in. I had enough space to access the rear wheels but not the...
Forum: C6 Corvette General Discussion
04-05-2013, 04:37 PM
Replies: 7
Views: 600
Posted By paz

Are all four 2006 Spindle Axle nuts the same?

Are all four 2006 Spindle (Axle) nuts the same? My right rear keeps loosening and I keep re-torqueing. I think it is time to replace it and Locktite it down.

When I look for the part online the...
Forum: C6 Corvette General Discussion
10-13-2008, 07:56 AM
Replies: 924
Views: 16,762
Posted By paz

In like Flint

In like Flint
Forum: C6 Corvette General Discussion
10-06-2008, 12:08 PM
Replies: 6
Views: 572
Posted By paz

Tire pressure for auto cross

To you auto cross people out there, what tire pressure do you recommend for a flat, dry auto cross (~70-75°F) course?
My brother-in-law was running a course and someone suggested that he increase...
Forum: C6 Corvette General Discussion
10-06-2008, 11:57 AM
Replies: 36
Views: 1,364
Posted By paz

Hey, I know that guy! Or someone just like him. I...

Hey, I know that guy! Or someone just like him. I was asked the same question a couple months ago. Same thing, a nice guy I know, just trying to make conversation and be complimentary.
Forum: C6 Corvette General Discussion
10-05-2008, 11:17 AM
Replies: 54
Views: 17,686
Posted By paz

Ridiculous! Most oil imported into the USA comes...

Ridiculous! Most oil imported into the USA comes from Canada, Mexico, Venezuela and, of course, the USA. Very little middle east makes it way to the US.
Forum: C6 Corvette General Discussion
09-23-2008, 04:43 PM
Replies: 101
Views: 2,668
Posted By paz

14.8 Average - Am I the only one telling the...

14.8 Average - Am I the only one telling the truth? LS2 Z51 Vert M6
Forum: C6 Corvette General Discussion
09-19-2008, 11:03 AM
Replies: 68
Views: 2,658
Posted By paz

With several days notice, you think you would...

With several days notice, you think you would have moved the car to higher ground. No wonder insurance rates are high!
Forum: C6 Corvette General Discussion
09-16-2008, 02:50 PM
Replies: 22
Views: 8,244
Posted By paz

Different angle pulling in/backing in?

Different angle pulling in/backing in?
Forum: C6 Corvette General Discussion
09-16-2008, 01:34 PM
Replies: 22
Views: 8,244
Posted By paz

I did this before buying my C6. The problem will...

I did this before buying my C6. The problem will exist only over a very short distance from street to driveway (and maybe from garage to driveway). Do NOT rely on giving slope specs to the...
Forum: C6 Corvette General Discussion
09-15-2008, 02:02 PM
Replies: 3
Views: 421
Posted By paz

Is there a site that describes the model year changes for C6?

Is there a site that describes the model year changes for 05, 06, 07, 08, & 09 C6s?
Forum: C6 Corvette General Discussion
09-15-2008, 11:24 AM
Replies: 13
Views: 2,827
Posted By paz

In this thread I described an install on a C6...

In this thread I described an install on a C6 vert, and how to run the wire to the center console without drilling holes.
http://forums.corvetteforum.com/showthread.php?t=1953865
I use a Scosche...
Showing results 1 to 25 of 428
 
Page 1 of 18
1
2
3
11
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 06:25 AM.