CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 5
1
2
3
Last »
Search: Posts Made By: GRTaylor
Showing results 1 to 25 of 122
Search took 1.37 seconds.
Forum: C7 Tech/Performance
07-10-2023, 09:50 AM
Replies: 9
Views: 701
Posted By GRTaylor

That's the first time I have seen that expression...

That's the first time I have seen that expression used. Good one. :D
Forum: C7 Tech/Performance
07-10-2023, 09:47 AM
Replies: 9
Views: 701
Posted By GRTaylor

Thanks to everyone that replied. It appears the...

Thanks to everyone that replied. It appears the 350 amp fuse is toast. It has 12.8 volts going into it and 1.2 volts coming out. That was the terminal the ratchet contacted when he dropped it.
Forum: C7 Tech/Performance
07-09-2023, 10:13 PM
Replies: 9
Views: 701
Posted By GRTaylor

Battery replacement gone wrong.

A neighbor friend of mine who is, or should I say was, a really good mechanic, offered to swap out the battery in my 2016 Stingray (non Z51). After installing the new battery and while tightening the...
Forum: C7 General Discussion
08-09-2017, 01:45 PM
Replies: 16
Views: 3,628
Posted By GRTaylor

500 Mile oil change

When I bought my 2016 Stingray (Non Z51) my dealer recommended changing the oil at 500 miles and then again at 5500 miles. The dealer gave me three free oil changes so I used the first two at 500 and...
Forum: C1 & C2 Corvettes
06-11-2012, 07:36 AM
Replies: 18
Views: 1,619
Posted By GRTaylor

I had a similar problem with my 67 427/390. Ran...

I had a similar problem with my 67 427/390. Ran fine under normal driving conditions but with wide open throttle it ran out of fuel. Turned out to be a weak fuel pump. I replaced the fuel pump and it...
Forum: C1 & C2 Parts
06-06-2012, 10:52 PM
Replies: 2
Views: 669
Posted By GRTaylor

58 seat frames

I have a friend who recently bought a disassembled 58 via the internet and after it was delivered he discovered he didn't have any seat frames. Would you sell the seats by themselves and if so, how...
Forum: C1 & C2 Corvettes
10-17-2010, 08:13 AM
Replies: 6
Views: 4,695
Posted By GRTaylor

I also use a shop crane to install the...

I also use a shop crane to install the engine/trans. and I have found that it is easier, for me anyway, to bolt everything together and then install it in the car. I use a hydraulic floor jack to...
Forum: C1 & C2 Corvettes
10-10-2010, 09:25 AM
Replies: 34
Views: 4,106
Posted By GRTaylor

One of the promoters for this show attended my...

One of the promoters for this show attended my Corvette Club's meeting in Morristown last night to personally invite my club to attend the show. He said that since the Cooper brothers were not...
Forum: C1 & C2 Corvettes
09-01-2010, 02:27 PM
Replies: 28
Views: 11,008
Posted By GRTaylor

I joined the 63-67 Sting Ray registry Saturday...

I joined the 63-67 Sting Ray registry Saturday while attending the Carlisle show. They had 58 members cars parked in the C2 Display area of the show field (59 after I parked my 67 there too). Their...
Forum: C1 & C2 Corvettes
08-08-2010, 08:53 AM
Replies: 4
Views: 605
Posted By GRTaylor

I used one of Zip's lift slings when I removed...

I used one of Zip's lift slings when I removed the body from the frame of my 67 convertable which is also a sidepipe equipped car. The metal clips were a tight fit but they worked fine. Maybe you...
Forum: C1 & C2 Corvettes
05-20-2010, 03:05 PM
Replies: 10
Views: 8,216
Posted By GRTaylor

:yesnod: Thanks for the reminder JohnZ. A...

:yesnod:

Thanks for the reminder JohnZ. A couple of months ago, the tail lights on my 67 started flashing when the switch was turned to the on or to the accessory position. They had acted...
Forum: C1 & C2 Corvettes
04-07-2010, 09:03 AM
Replies: 38
Views: 1,901
Posted By GRTaylor

:iagree: Except it's hearing loss in the right...

:iagree: Except it's hearing loss in the right ear.....due to wife trying to talk louder than the sidepipes.:rofl:
Forum: C1 & C2 Corvettes
04-07-2010, 07:45 AM
Replies: 9
Views: 5,118
Posted By GRTaylor

Penetrating oil may help loosen the nut. ...

Penetrating oil may help loosen the nut. http://www.kanolabs.com/ sells the best penetrating oil I have ever used.
Forum: C1 & C2 Corvettes
04-07-2010, 07:19 AM
Replies: 10
Views: 7,070
Posted By GRTaylor

c2ray, after I bought my 67 in West Virginia I...

c2ray, after I bought my 67 in West Virginia I contacted the WV DMV about doing a title history search on the Vette's VIN. The charge was $40 to do the search and they sent me copies of all prior...
Forum: C1 & C2 Corvettes
04-01-2010, 08:39 AM
Replies: 128
Views: 31,331
Posted By GRTaylor

After buying my 67 in West Virginia in 2002, I...

After buying my 67 in West Virginia in 2002, I paid a fee to the WV DMV to do a title history search on the car's VIN. The car's owner had died in a trucking accident (The Vette wasn't involved). His...
Forum: C1 & C2 Corvettes
04-01-2010, 05:02 AM
Replies: 62
Views: 3,899
Posted By GRTaylor

I can relate to that! In 1999 my 59 was...

I can relate to that! In 1999 my 59 was "finished" enough that I could start driving it. I took my 67 apart in 2003 and I've been putting it back together while continuing to "finish" the 59. The 67...
Forum: C1 & C2 Corvettes
09-25-2009, 06:11 PM
Replies: 17
Views: 774
Posted By GRTaylor

Ditto! Also, the Bendpak is made in America....

Ditto! Also, the Bendpak is made in America. :flag:
Forum: C1 & C2 Corvettes
09-25-2009, 05:38 PM
Replies: 3
Views: 421
Posted By GRTaylor

Have you tried Grundy Worldwide? They insure my...

Have you tried Grundy Worldwide? They insure my 59 and 67 Vettes. Around $800/yr for $120K total coverage on the cars. I do have my own garage but my driving record isn't perfect. Got caught...
Forum: C5 General
09-25-2009, 10:01 AM
Replies: 9
Views: 681
Posted By GRTaylor

Thanks Dave for the info. I will go ahead and...

Thanks Dave for the info. I will go ahead and have my dealer order the entire top assembly for me.
Forum: C5 General
09-24-2009, 09:06 PM
Replies: 9
Views: 681
Posted By GRTaylor

Thanks for the info guys. If the only difference...

Thanks for the info guys. If the only difference is the type and thickness of the top material and the deck seal then the newer top should fit my 99 just fine.
Forum: C5 General
09-24-2009, 06:02 PM
Replies: 9
Views: 681
Posted By GRTaylor

C5 convertible top question

My 99 Vette was recently broken into and to gain access they slit the convertible top/headliner and bent the bows of the top frame. It looks as if the top and frame will both require replacing. I've...
Forum: C1 & C2 Corvettes
12-24-2004, 02:12 PM
Replies: 15
Views: 1,511
Posted By GRTaylor

I don't know what kind of work you did to the...

I don't know what kind of work you did to the engine, but if you have adjusted the valves since the engine was run the last time you may have a couple of the rocker arms turned down too tight. That...
Forum: C5 Corvettes for Sale
07-20-2004, 08:43 PM
Replies: 15
Views: 717
Posted By GRTaylor

C5 was my first new Vette

:) I bought my first new Vette in July, 1999. It was a Torch Red 99 Convertible. I made my last payment on it last month and when I took it out of the garage last Saturday the odometer turned over...
Forum: Southeast
04-06-2004, 09:24 AM
Replies: 40
Views: 968
Posted By GRTaylor

Re: [SMC]&[ETCC] Cruise to visit Corvette Club in Morristown (98Pace97Coupe)

On behalf of the American Legend Corvette Club, we were delighted to have the SMC join us at our meeting last night. Seems like you have a great group of people who really enjoy their Corvettes....
Forum: C1 & C2 Corvettes
03-28-2004, 08:39 PM
Replies: 2
Views: 394
Posted By GRTaylor

Re: 67 dash paint (Nowhere Man)

[QUOTE]it is satin black


Thanks for the help.
Showing results 1 to 25 of 122
 
Page 1 of 5
1
2
3
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 03:48 AM.