CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 13
1
2
3
11
Last »
Search: Posts Made By: bobc997615
Showing results 1 to 25 of 323
Search took 1.42 seconds.
Forum: C5 Tech
03-18-2023, 09:45 AM
Replies: 20
Views: 1,223
Posted By bobc997615

Remove the vacuum actuator and access the blend...

Remove the vacuum actuator and access the blend actuator screws thru the glovebox. No need to remove the passenger lower air ducts (per the service manual)
Forum: C5 Tech
07-12-2020, 09:42 PM
Replies: 4
Views: 279
Posted By bobc997615

Mine failed in the winter months. EBCM started...

Mine failed in the winter months. EBCM started with a infrequent TC & AH faults till it finally failed in a period of about 3 months.

C1255 fault code

1999 Vert./V code EBCM.
Forum: C5 Tech
06-13-2020, 07:43 PM
Replies: 15
Views: 2,502
Posted By bobc997615

There was a year (98-99?) when the OEM rockers...

There was a year (98-99?) when the OEM rockers had the needle rollers failing. The rockers would "rotate" on the trunion due to several lost needles that hopefully made it down to the oil pan.
Forum: C1 & C2 Corvettes
04-25-2020, 07:34 PM
Replies: 13
Views: 1,578
Posted By bobc997615

https://cimg0.ibsrv.net/gimg/www.corvetteforum.com...

https://cimg0.ibsrv.net/gimg/www.corvetteforum.com-vbulletin/2000x1504/img_1422_2de55761bb49ec43fd1ee9ada4ebd66bca360626.jpg
Forum: C5 General
04-22-2020, 06:21 PM
Replies: 5
Views: 680
Posted By bobc997615

I have an extra 99-00 SWPS. PM me.

I have an extra 99-00 SWPS.

PM me.
Forum: C5 Tech
02-21-2020, 10:58 PM
Replies: 3
Views: 406
Posted By bobc997615

If yours is a Auto, the seal is the shaft seal on...

If yours is a Auto, the seal is the shaft seal on the seal plate between the trans and diff. Mine would "bleed" red tranny fluid backing down the driveway thru the weep hole. seal PN 24207010
Forum: C5 Tech
01-12-2020, 05:27 PM
Replies: 4
Views: 502
Posted By bobc997615

Diagram for grounds that I used ...

Diagram for grounds that I used

https://www.corvetteforum.com/forums/c5-tech/3519938-c5-engine-block-ground-locations.html
Forum: C5 Tech
01-10-2020, 02:55 PM
Replies: 4
Views: 502
Posted By bobc997615

Checked cleaned: G101 G102 G104/G108

Checked cleaned:
G101
G102
G104/G108
Forum: C5 Tech
01-09-2020, 09:26 AM
Replies: 4
Views: 502
Posted By bobc997615

Code C1255 when “hot”

1999 convertible just started to set a code C1255 only after 15-20 miles of driving. No communication to EBCM.

Possible cold solder joint inside the module? Already checked/ cleaned the grounds....
Forum: C5 General
06-16-2019, 06:29 PM
Replies: 10
Views: 1,603
Posted By bobc997615

I think I installed mine from the trunk side....

I think I installed mine from the trunk side. It's not as bad as you think.
Forum: C5 General
04-01-2018, 08:19 PM
Replies: 10
Views: 856
Posted By bobc997615

You can bend a larger angle "kink" in the strap...

You can bend a larger angle "kink" in the strap where the existing kink is (about 2 inches from the latch) to create a bit more tension to hold the latch "over center". At least this worked for me.
Forum: C5 Parts for Sale/Wanted
02-06-2017, 03:47 AM
Replies: 21
Views: 2,272
Posted By bobc997615

Does it come with the complete set of snaps?

Does it come with the complete set of snaps?
Forum: C5 General
02-17-2011, 07:56 PM
Replies: 23
Views: 2,253
Posted By bobc997615

The magnet is to activate the reed switch inside...

The magnet is to activate the reed switch inside the TPMS, so the location of the magnet is critical. Did my car in 2 minutes by placing the magnet inside of the valve stem.
Forum: C5 General
12-28-2010, 04:06 PM
Replies: 5
Views: 518
Posted By bobc997615

You need to replace the output shaft seal in the...

You need to replace the output shaft seal in the tranny. The original seal material (brown colored) tends to get "hard" in cold weather, hence the fluid seep. If you do a search, there are plenty of...
Forum: C5 General
12-07-2010, 05:42 PM
Replies: 35
Views: 1,612
Posted By bobc997615

There should be a o-ring seal on the flange face...

There should be a o-ring seal on the flange face of the oil drain bolt.
Forum: C5 General
11-03-2010, 08:50 PM
Replies: 18
Views: 5,252
Posted By bobc997615

I had a bad throttle body actuator (stepper...

I had a bad throttle body actuator (stepper motor?) that was "lazy" or as a electrical engineer would say "it has following error, input to output" but it never set a DTC. It was noticeable in the...
Forum: C5 Parts for Sale/Wanted
09-17-2010, 09:22 PM
Replies: 3
Views: 417
Posted By bobc997615

Are the attaching "snaps" mounted on the car or...

Are the attaching "snaps" mounted on the car or are they with the bra?
Forum: C5 General
03-25-2010, 08:13 PM
Replies: 18
Views: 13,255
Posted By bobc997615

Just installed a Silla rad, fit perfectly. You...

Just installed a Silla rad, fit perfectly. You don't need the AT cooler adapters & remove the orings for those adapters.
Forum: C5 General
02-26-2010, 10:30 PM
Replies: 11
Views: 609
Posted By bobc997615

http://forums.corvetteforum.com/c5-tech/2510509-tr...

http://forums.corvetteforum.com/c5-tech/2510509-trans-output-shaft-seal.html
Forum: C5 Tech
02-04-2010, 06:32 PM
Replies: 13
Views: 2,652
Posted By bobc997615

Just change the output shaft seal. I didn't have...

Just change the output shaft seal. I didn't have to remove the seal plate so I have a "spare" ring seal. It's not round but has a square crossection. I think GM changed the elastomer used for the...
Forum: C5 Tech
01-27-2010, 08:24 PM
Replies: 4
Views: 586
Posted By bobc997615

My 99 vert would leave a 20 foot drip trail of...

My 99 vert would leave a 20 foot drip trail of ATF in the morning backing out of the garage until I fixed it. The seal was about $60 2 years ago. A stealership quote was for about $700 to fix.
Forum: C5 Tech
01-26-2010, 09:39 PM
Replies: 4
Views: 586
Posted By bobc997615

The leak is the transmission output shaft seal....

The leak is the transmission output shaft seal. The outpur shaft seal is on a "plate" between the diff and tranny. You have to drop the drivetrain & remove the rear suspension to fix the seal. The...
Forum: C5 Parts for Sale/Wanted
01-24-2010, 09:07 PM
Replies: 2
Views: 299
Posted By bobc997615

PM sent

PM sent
Forum: C5 General
01-15-2010, 07:10 PM
Replies: 10
Views: 423
Posted By bobc997615

There is wheelmedic.com also in Ohio. With...

There is wheelmedic.com also in Ohio.

With the price to straighten a wheel you could buy a used one. Check out their pricing.
Forum: C5 General
01-12-2010, 08:11 PM
Replies: 7
Views: 727
Posted By bobc997615

No. The manifolds are different along with the...

No. The manifolds are different along with the air injection lines. H pipe is different also to match the manifolds (length).

Need to know what year to know what you might need to convert. But...
Showing results 1 to 25 of 323
 
Page 1 of 13
1
2
3
11
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 09:59 PM.