Search: Posts Made By: DONR
Showing results 1 to 25 of 436
Search took 4.89 seconds.
Forum: C1 & C2 Parts
Yesterday, 12:26 PM
Replies: 2
Views: 303
Posted By DONR

Yesterday, 12:21 AM
Replies: 3
Views: 344
Posted By DONR

ttt

ttt
Yesterday, 12:11 AM
Replies: 5
Views: 319
Posted By DONR

ttt

ttt
04-13-2024, 12:49 PM
Replies: 18
Views: 553
Posted By DONR

Safety Pins

If your pin hole is aligned well they should just push in pretty easy. You may have to bump the knockoff spinner a tad one way or another to get the right alignment.
Hope this helps!
03-28-2024, 12:40 AM
Replies: 6
Views: 244
Posted By DONR

Raptor Kit Gun

I used the Raptor kit gun to spray the underside of my fenders on my car hauling trailer. It did fine.
Applied about 3 coats on them. Holding up very well.
02-04-2024, 09:38 PM
Replies: 43
Views: 1,735
Posted By DONR

Well I took the original ignition switch apart...

Well I took the original ignition switch apart today. I can see now why it was failing.
You can see where it was arcing inside the switch., but look how long it lasted....
02-03-2024, 09:50 PM
Replies: 43
Views: 1,735
Posted By DONR

ttt Problem solved. Bad Ignition Switch

ttt
Problem solved. Bad Ignition Switch
02-03-2024, 01:07 PM
Replies: 43
Views: 1,735
Posted By DONR

Well here is another update Still puzzling. I did...

Well here is another update Still puzzling. I did drain the oil and no metal was in the oil.
I took the electrical power connection off to the external fuel pump eliminating the fuel going to the...
02-01-2024, 11:23 PM
Replies: 43
Views: 1,735
Posted By DONR

Here is the EFI system I have. Atomic EFI...

Here is the EFI system I have. Atomic EFI Throttle Body system. I do have a return line to the tank as well as a pressure regulator. This picture is when I had it on the 383 engine.
My next step...
02-01-2024, 07:42 PM
Replies: 43
Views: 1,735
Posted By DONR

Stumped

I ran a couple more test today.
1) I have not checked the starter under load. Both cables are fairly new. Will do that tomorrow. Did this today. There was no load drop during cranking.
5) I did add...
02-01-2024, 10:35 AM
Replies: 43
Views: 1,735
Posted By DONR

The compression on the engine is only 9 1/2 to 1....

The compression on the engine is only 9 1/2 to 1.
Jim brought up a good point. I did drain the oil and it did have a gas smell. What threw me was that no fuel come out of the cylinders when I took...
01-31-2024, 10:32 PM
Replies: 43
Views: 1,735
Posted By DONR

I will try and answer all responses up to now. ...

I will try and answer all responses up to now.
1) I have not checked the starter under load. Both cables are fairly new. Will do that tomorrow.
2) This started all of a sudden. I drove it about 10...
01-31-2024, 06:24 PM
Replies: 43
Views: 1,735
Posted By DONR

Stumped - 468 Big Block turns over 1/4 turn then nothing

I have been trying to figure out what is wrong with my 468 engine. New Starter, New Battery, checked battery cables and grounds. I have an MSD ignition system and MSD fuel injection.
It turns over...
Forum: C1 & C2 Parts
01-30-2024, 07:34 PM
Replies: 2
Views: 303
Posted By DONR

62 Bumpers

ttt
Will sell or trade. I have a 66 instrument cluster that need rebuilt.
01-27-2024, 01:11 PM
Replies: 17
Views: 715
Posted By DONR

Headlight bearing grease

When I had mine apart I used Mobil 1 tube grease. Still works fine after 10years.
Forum: C1 & C2 Parts
01-24-2024, 10:41 AM
Replies: 2
Views: 303
Posted By DONR

1962 rear bumpers & Door trim pieces

I have a set of rear bumpers, rear license plate trim, front bumperettes, and door trim for sale or trade.
The rear bumpers, and rear license plate trim have been rechromed and never installed....
01-22-2024, 11:09 AM
Replies: 5
Views: 319
Posted By DONR

1962 Bumpers

Thanks for the info. I will be moving these items over to the for sale section.
I am sure someone could use them.
01-21-2024, 11:10 PM
Replies: 5
Views: 319
Posted By DONR

1962 Bumpers/Trim Identification help

How do you identify rear bumpers and rear chrome license plate surround to see if they are original?
Also is there a way to identify the SS windshield side trim pieces to assure they are original....
01-11-2024, 12:17 AM
Replies: 20
Views: 1,817
Posted By DONR

Sale Pending for entire collection.

Sale Pending for entire collection.
01-10-2024, 12:13 AM
Replies: 20
Views: 1,817
Posted By DONR

CAG, I sent you a PM I just realized you just...

CAG, I sent you a PM
I just realized you just joined the forum.
PM me if you have any questions.
01-06-2024, 11:45 AM
Replies: 9
Views: 429
Posted By DONR

I used my stock shifter boot when I installed my...

I used my stock shifter boot when I installed my Silver Sport TKX 5 Speed. My ash tray also fit without any modifications....
01-01-2024, 09:54 PM
Replies: 20
Views: 1,817
Posted By DONR

ttt

ttt
12-22-2023, 12:23 AM
Replies: 12
Views: 723
Posted By DONR

Certificate

Is this what you are looking for. I have one that was a friend of mine acquired when he bought his new 95 R-1. He passed away a few years ago. I acquired this from his widow when I purchased some of...
12-12-2023, 01:14 PM
Replies: 20
Views: 1,817
Posted By DONR

Moderator can you please change the title of this...

Moderator can you please change the title of this post to:
For sale rare ZR-1 related memorabilia
Thanks You!
12-04-2023, 09:12 PM
Replies: 20
Views: 1,817
Posted By DONR

I have one person in front of you offering to buy...

I have one person in front of you offering to buy all of the ZR-1 stuff.
If that deal does not go through I will sell you the cam cover, clock, and the thermometer.
Showing results 1 to 25 of 436
 


 
Forum Jump


All times are GMT -4. The time now is 12:06 AM.