Search: Posts Made By: 33Chevy
Showing results 1 to 25 of 402
Search took 1.41 seconds.
Forum: C3 General
08-16-2023, 10:30 PM
Replies: 3
Views: 389
Posted By 33Chevy

What are these called?

Going through some leftover C3 parts and located these floor tubs. Trying to put a value on them but can't locate a source that sells them. Are they still made?

Thanks...
Forum: C3 General
09-02-2022, 02:52 PM
Replies: 3
Views: 366
Posted By 33Chevy

Thanks!

Thanks!
Forum: C3 General
09-02-2022, 12:35 PM
Replies: 3
Views: 366
Posted By 33Chevy

Where does this ground cable go? (78 Vette)

Had to install a set of valve cover gaskets in a 1978 vette and noticed the previous installer had this ground strap bolted to the upper rear valve cover bolt (pass side)and not connected anywhere...
Forum: C3 General
09-01-2022, 01:37 PM
Replies: 2
Views: 517
Posted By 33Chevy

Thanks...I just pulled the spring button from...

Thanks...I just pulled the spring button from inside the column since I need to get back into it again later.
Forum: C3 General
08-31-2022, 06:10 PM
Replies: 2
Views: 517
Posted By 33Chevy

1978 Vette horn relay or fuse location

A neighbor dropped off his 78 vette so I could look at his A/C. While here the horn button fell apart, had to disconnect the battery to shut it off. Where is either the horn fuse or relay so I can...
05-06-2018, 08:54 PM
Replies: 2
Views: 489
Posted By 33Chevy

These seat cover replacement clips (1972)

Where can I buy a handful of these clips without buying an entire install kit? Thanks!

http://i15.photobucket.com/albums/a383/EdJacobi/Corvetteseatclip.jpg...
12-05-2016, 01:44 PM
Replies: 0
Views: 576
Posted By 33Chevy

80-82? speedometer

Speedometer was serviced but never installed...not sure what year flag it has.

$50? plus S/H
07-20-2016, 08:34 PM
Replies: 5
Views: 2,557
Posted By 33Chevy

The car was bought from an insurance company, the...

The car was bought from an insurance company, the buyer couldn't get it running after installing a new drive-line, interior etc. and my buddy picked it up. We can only assume that the door lock, BCM...
07-16-2016, 11:03 AM
Replies: 5
Views: 2,557
Posted By 33Chevy

When I visited his shop first thing I asked for...

When I visited his shop first thing I asked for was volt meter to check the battery charge...a battery load tester was on the bench so I used it..battery is up to snuff & under load.

Just...
07-16-2016, 09:53 AM
Replies: 5
Views: 2,557
Posted By 33Chevy

Starting a 2008 Corvette stolen recovery..(VATS- On-Star etc)

Posted this on another forum (fuel injection forum)...looks like I could use the wiring schematic for both the BCM and PCM if anyone has a copy?

A buddy just picked up a stolen recovery 2008...
02-13-2016, 05:04 PM
Replies: 138
Views: 42,788
Posted By 33Chevy

I live about 800 yard from the NY/Quebec, Canada...

I live about 800 yard from the NY/Quebec, Canada border, 45 minutes south of Montreal and 2 miles from Vermont. I can offer a staging/storage point and often receive packages for my Canadian buddies....
Forum: C3 General
07-04-2014, 12:27 PM
Replies: 4
Views: 620
Posted By 33Chevy

Thanks...I thought it was an 82...but with it...

Thanks...I thought it was an 82...but with it going back and forth and not having my 82 to compare it to...wasn't sure.
Forum: C3 General
07-04-2014, 12:08 PM
Replies: 4
Views: 620
Posted By 33Chevy

What year this speedo

Years ago I picked up this extra speedo to have converted to 145mph by a well known speedo shop.

Almost a year later it arrived back rebuilt and converted but with corvette/flag that didn't match...
06-24-2014, 06:47 AM
Replies: 5
Views: 12,341
Posted By 33Chevy

Thanks guys for the great responses! It...

Thanks guys for the great responses!

It was a bad fuel pump!!! Thanks Again!
06-23-2014, 11:20 PM
Replies: 5
Views: 12,341
Posted By 33Chevy

Thanks Fuse is good...so it looks like the...

Thanks

Fuse is good...so it looks like the 10a fuse is powered by the relay red wire which sends 12v to the pump via the tan/white?

If so, I should be able to jump the relay "orange" to the...
06-23-2014, 09:23 PM
Replies: 5
Views: 12,341
Posted By 33Chevy

87 fuel pump and relay wire colors (schematic?)

Working on a friends 87 vette, spark but no fuel pressure, pump not activating. Have it narrowed down the fuel pump relay.

On the relay - Orange Line (E) has constant 12v and GRN/wht Line (C)...
04-06-2014, 11:07 PM
Replies: 4
Views: 563
Posted By 33Chevy

PM sent

PM sent
04-05-2014, 09:33 PM
Replies: 4
Views: 563
Posted By 33Chevy

OK thanks..I have a couple of sets of "non D...

OK thanks..I have a couple of sets of "non D port" shorties and they interfere with the knock sensor on the passenger side. Maybe the vette shorties clear that sensor so I don't have to move it.
...
04-03-2014, 07:54 AM
Replies: 4
Views: 563
Posted By 33Chevy

WTB: Shorty D port headers

Looking for a set of LT1 D port headers for a streetrod project. O2 bung on each side would be great.

Thanks
06-25-2013, 07:39 AM
Replies: 2
Views: 373
Posted By 33Chevy

Guess I could have worded the request better..I'm...

Guess I could have worded the request better..I'm looking for a set of tube headers to try on the project..a set with O2 bungs would be better.
06-24-2013, 09:22 PM
Replies: 2
Views: 373
Posted By 33Chevy

WTB: headers w/o2 bungs

Installing a 95 LT1 (Z28) engine in a 37 Chevy sedan and figure a set of C4 SBC headers with collectors would work. Need bungs on both sides if possible. (have bungs if needed).

Thanks
06-24-2013, 09:15 PM
Replies: 4
Views: 585
Posted By 33Chevy

Might try this link, the vette bins are on the...

Might try this link, the vette bins are on the bottom.

http://www.eecis.udel.edu/~davis/z28/
04-22-2013, 03:25 PM
Replies: 0
Views: 251
Posted By 33Chevy

WTB: Big Cap HEI TPI distributor

Disregard....just bought a new pickup coil to try first.


Have a couple of big cap HEI TPI distibutors, one is in parts and the other continues to code 45 (electronic sparking timing...
08-22-2012, 10:18 PM
Replies: 3
Views: 479
Posted By 33Chevy

Anyway to include a picture from a parts manual?...

Anyway to include a picture from a parts manual? I might have the parts laying around.
07-31-2012, 07:30 AM
Replies: 6
Views: 839
Posted By 33Chevy

Had to use it on my 82! Still have the rest of...

Had to use it on my 82! Still have the rest of the duct work pieces.
Showing results 1 to 25 of 402
 


 
Forum Jump


All times are GMT -4. The time now is 09:55 AM.