Search: Posts Made By: Hammerhead Fred
Showing results 1 to 25 of 499
Search took 1.41 seconds.
Yesterday, 06:55 AM
Replies: 5
Views: 143
Posted By Hammerhead Fred

Because it seals against the damper not the...

Because it seals against the damper not the crankshaft.
03-16-2024, 09:52 AM
Replies: 9
Views: 265
Posted By Hammerhead Fred

Likely a reference to the Instrument Panel...

Likely a reference to the Instrument Panel harness but that depends on which wiring diagram source you're using.
02-27-2024, 05:18 PM
Replies: 18
Views: 409
Posted By Hammerhead Fred

11VFM1 1 =1971 model year 1 = Chevrolet V...

11VFM1
1 =1971 model year
1 = Chevrolet
V = Corvette
FM = AM/FM Stereo
1 = revision #1
02-03-2024, 07:14 AM
Replies: 3
Views: 259
Posted By Hammerhead Fred

Goes to the Radio Capacitor connection on the...

Goes to the Radio Capacitor connection on the Ignition Switch
Should be hot from the wiper fuse in the fuse block
01-10-2024, 07:40 AM
Replies: 3
Views: 364
Posted By Hammerhead Fred

Wiper door relay. See it here...

Wiper door relay.
See it here...
Forum: C3 General
11-27-2023, 09:18 AM
Replies: 2
Views: 192
Posted By Hammerhead Fred

Install your hardtop and adjust the windows for...

Install your hardtop and adjust the windows for their very best fit against the hardtop weather strips.
Remove the hardtop and then adjust the soft top for the best fit against the windows.
The...
11-13-2023, 07:51 AM
Replies: 2
Views: 169
Posted By Hammerhead Fred

Could you provide more detail on this...

Could you provide more detail on this conversion/swap?
What 72 volt meter did you "convert" to?
The OEM 72 C3 gauge cluster was also an amp meter.
Forum: C3 General
11-08-2023, 09:07 AM
Replies: 3
Views: 408
Posted By Hammerhead Fred

Here it is.... BAT...

Here it is.... BAT (https://bringatrailer.com/listing/1971-chevrolet-corvette-109/)
And here on Hemmings (https://www.hemmings.com/auction/1971-chevrolet-corvette-859201/sold)

In Virginia you can...
Forum: C3 General
11-05-2023, 06:36 AM
Replies: 8
Views: 456
Posted By Hammerhead Fred

That's what I meant: Using the attaching screws...

That's what I meant: Using the attaching screws where the pin receiver is mounted onto the rear bow loosen the screws and the entire receiver can be "adjusted" laterally (you'll see the screws pass...
Forum: C3 General
11-04-2023, 05:51 PM
Replies: 8
Views: 456
Posted By Hammerhead Fred

It's the bow pins that are adjustable. They can...

It's the bow pins that are adjustable. They can be adjusted via their attachment to the rear bow (one screw on either side of the pin) from inside the top.
10-13-2023, 09:52 AM
Replies: 33
Views: 906
Posted By Hammerhead Fred

I have the stock configuration 2.5" exhaust...

I have the stock configuration 2.5" exhaust mounted on my 71 4-speed (4-speeds came with welded cross members).
While I'd prefer being able to remove the exhaust and/or cross member: I've never had...
Forum: C3 General
09-21-2023, 01:05 PM
Replies: 9
Views: 337
Posted By Hammerhead Fred

Try testing the tach independent of the...

Try testing the tach independent of the distributor to narrow down your issue.
To do this you can disconnect the cable from the distributor and chuck a hand drill to the cable end and spin up the...
08-18-2023, 07:04 AM
Replies: 5
Views: 270
Posted By Hammerhead Fred

Zip sells the Lectric Limited harness

Zip sells the Lectric Limited harness
Forum: C3 General
08-12-2023, 11:25 AM
Replies: 3
Views: 376
Posted By Hammerhead Fred

The above is the best solution if you can reuse...

The above is the best solution if you can reuse the ferrule.
I had one of my ferrules break in half and was unable to locate a new one.
I ended up substituting a electrical connector crimp in place...
Forum: C3 General
07-11-2023, 04:12 PM
Replies: 3
Views: 318
Posted By Hammerhead Fred

Your understanding is pretty spot on. On the...

Your understanding is pretty spot on. On the radiator just below the radiator cap you should see embossed into the radiator tank a line with the phrase "cool fill" or something similar. As long as...
07-11-2023, 07:20 AM
Replies: 25
Views: 1,091
Posted By Hammerhead Fred

Try the method shown the link below? Go to this...

Try the method shown the link below?
Go to this link and start with post #8 (https://www.corvetteforum.com/forums/c3-general/3674046-here-we-go-again-coil-spring-installation.html)
07-06-2023, 02:28 PM
Replies: 25
Views: 1,091
Posted By Hammerhead Fred

Go to this thread and see post #8...

Go to this thread and see post #8 (https://www.corvetteforum.com/forums/c3-general/3674046-here-we-go-again-coil-spring-installation.html) for detailed photos on how to use the spring compressor.
06-25-2023, 11:47 AM
Replies: 31
Views: 1,033
Posted By Hammerhead Fred

I had good results using a long pry bar. Come...

I had good results using a long pry bar.
Come in from the wheel opening, Insert between the crossmember and frame and push down on the bar toward the ground.
Do no pull up on the bar because when...
06-14-2023, 04:55 PM
Replies: 4
Views: 373
Posted By Hammerhead Fred

Caulking cord/rope available in your local big...

Caulking cord/rope available in your local big box store in the weather stripping isle.
06-14-2023, 06:36 AM
Replies: 7
Views: 518
Posted By Hammerhead Fred

Often a sign that the headlight switch is...

Often a sign that the headlight switch is overheating.
Forum: C3 General
06-10-2023, 11:33 AM
Replies: 6
Views: 344
Posted By Hammerhead Fred

If you could post the casting number from the...

If you could post the casting number from the rear of the block you'd likely get better answers.
The 1997 Chevy Tahoe 2WD 4WD 1/2 ton & 3/4 ton appears to have the following FKA, FKB, FKF, FLA, FLD,...
05-18-2023, 07:20 AM
Replies: 8
Views: 463
Posted By Hammerhead Fred

You should check the condition of the sensing...

You should check the condition of the sensing wire connected to the alternator.
Over time the wire strands wear/break right at the connector or the connector can become corroded preventing the...
04-29-2023, 04:33 PM
Replies: 34
Views: 1,441
Posted By Hammerhead Fred

Noise from rear area only with heavy braking; ...

Noise from rear area only with heavy braking; perhaps it's a loose spare tire carrier.
04-27-2023, 04:07 PM
Replies: 2
Views: 338
Posted By Hammerhead Fred

This should help your troubleshooting... ...

This should help your troubleshooting...
https://cimg6.ibsrv.net/gimg/www.corvetteforum.com-vbulletin/566x800/69ammetercircuitmod_94362097d3bcbc95f7bd6335f97515472f948427.jpg
04-24-2023, 05:32 PM
Replies: 6
Views: 401
Posted By Hammerhead Fred

Symptom sound like a bad/poor ground somewhere. ...

Symptom sound like a bad/poor ground somewhere.
Try removing the fuse you installed for the courtesy lights an see if the parking lights go completely out.
Showing results 1 to 25 of 499
 


 
Forum Jump


All times are GMT -4. The time now is 09:51 PM.