CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: Randy93
Showing results 1 to 25 of 500
Search took 1.57 seconds.
Forum: C4 Parts for Sale/Wanted
05-16-2011, 10:00 AM
Replies: 0
Views: 305
Posted By Randy93

Please delete

Mods, please delete
Forum: C4 Tech/Performance
09-10-2009, 11:09 PM
Replies: 17
Views: 822
Posted By Randy93

Got the new opti in and car runs good, but the...

Got the new opti in and car runs good, but the drivers side has a miss. When I replaced the old wires(which is the reason for the opti dying) it did not miss.
So could a new opti have ne side that...
Forum: C4 Tech/Performance
09-09-2009, 02:09 PM
Replies: 17
Views: 822
Posted By Randy93

Thanks for the pic, I see it now. I was looking...

Thanks for the pic, I see it now. I was looking for a actual key. :D
Forum: C4 Tech/Performance
09-09-2009, 10:05 AM
Replies: 17
Views: 822
Posted By Randy93

Hope your right, I looked at the old opti and I...

Hope your right, I looked at the old opti and I don't see a void. I thought only the 95-96 had the key?

Thanks
Forum: C4 Tech/Performance
09-08-2009, 04:42 PM
Replies: 17
Views: 822
Posted By Randy93

Need realigning new opti

I pulled the old opti off and am waiting for new opti to arrive, well I was looking at it and then for some reason I turned the the rotor. :ack:

Now I need to figure out how to realign the opti,...
Forum: C4 Tech/Performance
09-06-2009, 05:30 PM
Replies: 27
Views: 1,572
Posted By Randy93

:iagree::withstupid:

:iagree::withstupid:
Forum: C4 Tech/Performance
09-04-2009, 07:58 PM
Replies: 24
Views: 1,508
Posted By Randy93

Straight water would not clog an injector,...

Straight water would not clog an injector, running Sea Foam and injector cleaner back to back would really be hard on the seals and internals of the FI's.
Running Carb cleaner will kill a FI...
Forum: C4 Tech/Performance
09-04-2009, 05:37 PM
Replies: 4
Views: 332
Posted By Randy93

There are threads, it should have come w/tool to...

There are threads, it should have come w/tool to put on the cap. Cap would not have come with it.
Forum: C4 General Discussion
09-04-2009, 04:27 PM
Replies: 17
Views: 539
Posted By Randy93

If it died driving it is not vats(key) related,...

If it died driving it is not vats(key) related, most likely ICM or coil, if you had codes then I would say the opti.

The ICM is my nbr 1 choice, you cannot test them. But I would get some...
Forum: C4 Tech/Performance
09-04-2009, 04:15 PM
Replies: 4
Views: 332
Posted By Randy93

the threads are on the inside for the cap and...

the threads are on the inside for the cap and yes, you need the rubber grommet.
Forum: C4 Tech/Performance
09-04-2009, 04:09 PM
Replies: 2
Views: 320
Posted By Randy93

Weird, I thought the pass. side fan was the...

Weird, I thought the pass. side fan was the primary. :willy:

Thanks for checking, I must have my relays crossed.
Forum: C4 Tech/Performance
09-04-2009, 03:41 PM
Replies: 2
Views: 320
Posted By Randy93

Fan question

W/ac ON, should both fans come on or just the primary?

Thanks!!
Forum: C4 Tech/Performance
09-04-2009, 02:22 PM
Replies: 11
Views: 422
Posted By Randy93

I just put them on, that is what started this...

I just put them on, that is what started this mess.
I am thinking ICM also, they don't seem to last long, just put this one one about 2-3 yrs ago.
Forum: C4 Tech/Performance
09-04-2009, 01:56 PM
Replies: 11
Views: 422
Posted By Randy93

It seems to die when temp gets to 175ish degrees,...

It seems to die when temp gets to 175ish degrees, I would think it would have burned off the coolant at that temp?
Forum: C4 Tech/Performance
09-04-2009, 11:33 AM
Replies: 1
Views: 336
Posted By Randy93

If you let a sensor stay bad long enough, it will...

If you let a sensor stay bad long enough, it will kill the ECM.
If both cars are 92's and 6sp's, then you can swap them. You cannot swap a auto ECM w/6sp, the ECM's are different.
Forum: C4 Tech/Performance
09-04-2009, 10:12 AM
Replies: 11
Views: 422
Posted By Randy93

No codes, but it runs now for about 5 minutes and...

No codes, but it runs now for about 5 minutes and then just dies.
Could getting the opti wet put a strain on the ICM and caused this?

Cause I have read other peoples threads about this and it...
Forum: C4 Tech/Performance
09-03-2009, 05:22 PM
Replies: 12
Views: 403
Posted By Randy93

Stock tune is for a 48mm TB, the PCM does not...

Stock tune is for a 48mm TB, the PCM does not know about the extra air and yes can compensate for it to some extent, but all the add ons will make it very hard for the PCM to do together and that is...
Forum: C4 Tech/Performance
09-03-2009, 04:24 PM
Replies: 28
Views: 2,105
Posted By Randy93

Airfoils only really work at high speeds,...

Airfoils only really work at high speeds, fundamentally it is a sound principal, but at normal driving speeds the air is not comimg in fast enough for them to be effective.

If you drive at...
Forum: C4 Tech/Performance
09-03-2009, 04:18 PM
Replies: 12
Views: 403
Posted By Randy93

If I read it correctly, you add 52mm TB, intake,...

If I read it correctly, you add 52mm TB, intake, Bosch III, Shorty headers and B&B exhaust?

Then yes, you need a tune real bad!!
Forum: C4 Tech/Performance
09-03-2009, 02:43 PM
Replies: 11
Views: 509
Posted By Randy93

Defect was only in the original design, it was...

Defect was only in the original design, it was fixed before your car was made. It was in the mid to late 80's when they had problems, so unless you buy a used one, there is no chance you will get a...
Forum: C4 Tech/Performance
09-03-2009, 02:36 PM
Replies: 22
Views: 908
Posted By Randy93

with a cat 5 hurricane behind you right!! ...

with a cat 5 hurricane behind you right!! :rofl:

Mine is 1750-1800 at 70mph
Forum: C4 Tech/Performance
09-03-2009, 02:34 PM
Replies: 22
Views: 908
Posted By Randy93

WHAT??????? :crazy:

WHAT??????? :crazy:
Forum: C4 Tech/Performance
09-03-2009, 02:31 PM
Replies: 11
Views: 422
Posted By Randy93

Thought my leak was caused by a bad hose, well...

Thought my leak was caused by a bad hose, well after examining the T housing it wasn't. My housing is pitted and has a lot of build up, especially the underside of the snout, so I would say if you...
Forum: C4 Tech/Performance
09-03-2009, 01:51 PM
Replies: 11
Views: 422
Posted By Randy93

I thought screws backing out were the 1st gen MSD...

I thought screws backing out were the 1st gen MSD opti's?

Mine is a Delphi and I will use a hairdrier, thanks for the quick responses!! :thumbs:
Forum: C4 Tech/Performance
09-03-2009, 12:38 PM
Replies: 11
Views: 422
Posted By Randy93

Weird opti problem

On my way to run errands yesterday, the car died on me. Looked under the hood and I had tighened the radiator hose on the pass. side all the way and it was leaking pretty bad.

Here is the weird...
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 04:38 PM.