CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 3
1
2
3
Search: Posts Made By: tholm1
Showing results 1 to 25 of 62
Search took 1.31 seconds.
Forum: C4 Tech/Performance
07-21-2008, 03:34 PM
Replies: 2
Views: 4,781
Posted By tholm1

Does anyone have any experience using datamaster...

Does anyone have any experience using datamaster to know what a normal O2 voltage should be and if I should be getting a stable reading or should it oscilate between 150 and 800 mV rapidly?
Forum: C4 Tech/Performance
07-18-2008, 12:38 AM
Replies: 2
Views: 4,781
Posted By tholm1

LT1 idles rough and stalls when warm, Long term counts high

I am absolutely stumped. My 95 A4 LT1 runs like a champ for the first 5-10 minutes after start-up. Once I get to about 195 deg F, the car simply will not idle smoothly, eventually stalls out...
Forum: C4 Tech/Performance
07-10-2008, 10:47 AM
Replies: 39
Views: 12,893
Posted By tholm1

My car is also running bad when it gets hot. I...

My car is also running bad when it gets hot. I changed out the coil with a new one and now the car won't fire at all. I checked for spark at one of the cylinder and got nothing. I put the orginal...
Forum: C4 General Discussion
07-10-2008, 10:19 AM
Replies: 31
Views: 1,425
Posted By tholm1

Klondike, My car is doing the same thing....

Klondike,

My car is doing the same thing. Everytime I've had a bad O2 sensor the check engine light had come on and thrown a code. I'm thinking the ICM is on the verge of shorting out and the heat...
Forum: C4 Tech/Performance
07-08-2008, 09:37 AM
Replies: 2
Views: 381
Posted By tholm1

Unfortunately I took the water pump off again to...

Unfortunately I took the water pump off again to reinstall the optispark. It runs good now for a few minutes and then starts to idle rough and stumbles when I give it gas. Considering everything...
Forum: C4 Tech/Performance
06-30-2008, 10:25 AM
Replies: 2
Views: 381
Posted By tholm1

Stalls at idle, but will run at high RPMs

I took the WP, optispark and front hub/balancer off this weekend to replace the rotating oil seals on the timing cover. When I put everything back together the car will not idle. I can rev the engine...
Forum: C4 Parts for Sale/Wanted
04-27-2008, 05:49 PM
Replies: 4
Views: 470
Posted By tholm1

WTB LT1 Crank Hub Puller

Looking for a Kent Moore J-39046 tool for my LT1
Forum: C4 General Discussion
10-10-2007, 01:41 PM
Replies: 1
Views: 454
Posted By tholm1

Paint Shop in the Birmingham/Tuscaloosa, AL area

I'm new to the Birmingham area. Does anyone know of a good body shop in the Birmingham area to shoot a hood and bumper (possibly the whole car)?
Forum: C4 Tech/Performance
08-23-2007, 12:10 PM
Replies: 20
Views: 4,372
Posted By tholm1

The Sears Grand in Austin gave me an oil change...

The Sears Grand in Austin gave me an oil change without taking the old oil out first. It took me a couple of weeks to figure out what was going on. I didn't have any mechanical damage, however it did...
Forum: C4 Tech/Performance
07-18-2007, 05:46 PM
Replies: 49
Views: 2,229
Posted By tholm1

I'm just putting my 4th set of Nitto 555s on my...

I'm just putting my 4th set of Nitto 555s on my 95 (140k miles). The tread wear is outstanding and they really hook up well in the rain. I've been getting about 35k miles out of a set.
Forum: C4 Tech/Performance
03-28-2007, 05:37 PM
Replies: 21
Views: 1,007
Posted By tholm1

I was looking at the superexhaust.com website and...

I was looking at the superexhaust.com website and it looks like the $923 exhaust is the 2.5" system.
Forum: C4 Tech/Performance
01-28-2007, 02:13 PM
Replies: 2
Views: 506
Posted By tholm1

I've got the jam nut off no problem. The outer...

I've got the jam nut off no problem. The outer tie rod just will not unsrew off the inner tie rod. Anyone change the inner tie rod with the steering rack still on the car?
Forum: C4 Tech/Performance
01-26-2007, 07:30 PM
Replies: 2
Views: 506
Posted By tholm1

Outer tie rod end seized

I've tried all day long and I can not get the driver side outer tie rod end to unscrew off the inner tie rod end. I've tried heat and a lot of penetrating oil. I'm starting to round off the hex part...
Forum: C4 Tech/Performance
10-19-2006, 02:30 PM
Replies: 19
Views: 5,057
Posted By tholm1

Trick Flow makes a 195cc LT1 head that I've heard...

Trick Flow makes a 195cc LT1 head that I've heard good stuuf about. I would imagine a complete port job on a LT1 intake and Trick Flow 195cc heads would let the engine breath a little deeper...Trick...
Forum: C4 Tech/Performance
09-29-2006, 11:45 AM
Replies: 28
Views: 4,113
Posted By tholm1

The twin turbo GS is in fact a Callaway. It's a...

The twin turbo GS is in fact a Callaway. It's a Callaway SuperNatural 450. With the introduction of the LTx engines Callaway stopped the B2K option and went with a N/A engine package. You could still...
Forum: C4 Tech/Performance
06-05-2006, 10:10 AM
Replies: 22
Views: 1,598
Posted By tholm1

My 95 LT1 does the same exact leaking smoking...

My 95 LT1 does the same exact leaking smoking scenario. I would check around the back of the intake manifold. The front and rear intake manifold seals on the LTX motor are just RTV silicon and fail...
Forum: C4 Tech/Performance
04-03-2006, 03:11 PM
Replies: 3
Views: 460
Posted By tholm1

This weekend I'll be sure to take the throttle...

This weekend I'll be sure to take the throttle body off and clean it up real good
Forum: C4 Tech/Performance
04-03-2006, 11:38 AM
Replies: 3
Views: 460
Posted By tholm1

Rough Idle driving me crazy!

I have a rough idle that goes away with a little bit of pedal. When I start the car it takes a little bit of cranking before the engine fires. Sometimes in the morning it will even blow out smoke. I...
Forum: C4 Tech/Performance
12-06-2005, 12:13 PM
Replies: 24
Views: 13,735
Posted By tholm1

The new rwd northstar engine found in the new...

The new rwd northstar engine found in the new LR/SRX/STS share engine mounts with the LSX family of engines. Rememeber that the new vette shares a platform with the XLR. I think using a salvaged...
Forum: C4 Tech/Performance
12-06-2005, 12:02 PM
Replies: 24
Views: 13,735
Posted By tholm1

The new rwd northstar engine found in the new...

The new rwd northstar engine found in the new LR/SRX/STS share engine mounts with the LSX family of engines. Rememeber that the new vette shares a platform with the XLR. I think using a salvaged...
Forum: C4 Tech/Performance
11-03-2005, 06:37 PM
Replies: 9
Views: 1,559
Posted By tholm1

Mine was doing the same thing, the plastic stop...

Mine was doing the same thing, the plastic stop that is connected to the window strikes a metal L-bracket bolted to the door frame...guess which one breaks first. The plastic stop on the glass also...
Forum: C4 Tech/Performance
10-24-2005, 04:52 PM
Replies: 4
Views: 730
Posted By tholm1

I inquired to them about the system and this is...

I inquired to them about the system and this is what I got back:
"The system uses 3" pipes through the converters and tapers down to 2-1/2" on
the outlet side of the converters. In addition to the...
Forum: C4 Tech/Performance
10-21-2005, 05:24 PM
Replies: 5
Views: 699
Posted By tholm1

Optispark from Summit is $289 for vented...

Optispark from Summit is $289 for vented (includes 96)
http://store.summitracing.com/default.asp?Ntt=optispark&x=0&y=0&Ntk=KeywordSearch&DDS=1&searchinresults=false&N=0&target=egnsearch.asp
Forum: C4 Tech/Performance
10-18-2005, 11:24 AM
Replies: 14
Views: 556
Posted By tholm1

Street and Performance has them! ...

Street and Performance has them!

http://www.hotrodlane.cc/
Forum: C4 Tech/Performance
10-16-2005, 09:55 PM
Replies: 14
Views: 556
Posted By tholm1

I'm pretty sure the air is injected into the...

I'm pretty sure the air is injected into the exhaust at the manifold and the CATS don't have an air tube on them.
Showing results 1 to 25 of 62
 
Page 1 of 3
1
2
3


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 05:51 AM.