CorvetteForum - Chevrolet Corvette Forum Discussion

 
Page 1 of 9
1
2
3
Last »
Search: Posts Made By: Fast one
Showing results 1 to 25 of 205
Search took 1.42 seconds.
Forum: C5 General
Yesterday, 12:52 PM
Replies: 4
Views: 84
Posted By Fast one

Or tune it out with software and pass NYS...

Or tune it out with software and pass NYS inpections
Forum: C5 General
04-12-2024, 09:51 AM
Replies: 40
Views: 1,219
Posted By Fast one

That metal support is what I called an adjustable...

That metal support is what I called an adjustable cross frame in the first reply. I had the bumper off last week and while it was off the metal support was moved toward the front of the car about...
Forum: C5 Tech
04-10-2024, 02:34 PM
Replies: 4
Views: 659
Posted By Fast one

I believe it is: damper #917266, shell #917074CS,...

I believe it is: damper #917266, shell #917074CS, 4 rib rear pulley #1916734 and hub # 916032-M3. This is the second one down on the ATI Chevy, Y body chart for a '97-'04 LS1. The hub is steel, the...
Forum: C5 General
04-10-2024, 02:13 PM
Replies: 40
Views: 1,219
Posted By Fast one

A photo or two from the side with the hood closed...

A photo or two from the side with the hood closed would help.
Forum: C5 General
04-09-2024, 10:04 AM
Replies: 40
Views: 1,219
Posted By Fast one

Have you tried adding washers between the bumper...

Have you tried adding washers between the bumper and frame where the center front mounting fasteners are? This would lift the center of the bumper edge up to match the hood. Is the hood warped where...
Forum: C5 Tech
04-04-2024, 06:11 PM
Replies: 8
Views: 309
Posted By Fast one

If all else fails, a radiator pressure test kit...

If all else fails, a radiator pressure test kit from Harbor Freight ($90) allows quick testing of the coolant system without running the engine or taking anything apart.
Forum: C5 General
04-02-2024, 09:54 AM
Replies: 16,797
Views: 1,259,879
Posted By Fast one

How tight or sloppy is the LS2 chain when it's...

How tight or sloppy is the LS2 chain when it's first installed?
Forum: C5 Tech
03-29-2024, 07:19 PM
Replies: 8
Views: 262
Posted By Fast one

Aren't there kits to replace the knob with other...

Aren't there kits to replace the knob with other choices and eliminate the button on the C5 shifter?
Forum: C5 Tech
03-27-2024, 07:43 PM
Replies: 14
Views: 314
Posted By Fast one

There's also a correct socket for these sensors.

There's also a correct socket for these sensors.
Forum: C5 General
03-26-2024, 08:44 PM
Replies: 16
Views: 353
Posted By Fast one

That doesn't look like it's in park, the top of...

That doesn't look like it's in park, the top of the arm looks like it's pointing straight up which could be D3. Here's what the arm looks like in park, the end of the arm faces the rear of the car...
Forum: C5 General
03-25-2024, 01:07 PM
Replies: 16
Views: 353
Posted By Fast one

There's an adjusting clip on that side of the...

There's an adjusting clip on that side of the cable so the shifter position sychronizes to the transmission side as seen here:...
Forum: C5 General
03-25-2024, 12:07 PM
Replies: 16
Views: 353
Posted By Fast one

Was the bushing changed at the shifter end of the...

Was the bushing changed at the shifter end of the cable or the transmission side?
Forum: C5 General
03-20-2024, 08:26 PM
Replies: 43
Views: 1,599
Posted By Fast one

Aston Martin has a lot of nice colors that would...

Aston Martin has a lot of nice colors that would look good on their website in the configure setup.
Forum: C5 Tech
03-14-2024, 05:42 PM
Replies: 15
Views: 452
Posted By Fast one

Have you taken the fob apart and lightly cleaned...

Have you taken the fob apart and lightly cleaned the circuit board contacts where the battery prongs touch with a pencil eraser? You should have a backup fob, they're cheap on e-bay. The receiver...
Forum: C5 General
03-14-2024, 05:33 PM
Replies: 23
Views: 2,496
Posted By Fast one

Do the silicone hoses last longer in ratio to...

Do the silicone hoses last longer in ratio to their cost as in three times longer life if the cost is three times more expensive and are they easier to remove after the clamp is taken off than normal...
Forum: C5 Tech
03-14-2024, 08:53 AM
Replies: 6
Views: 254
Posted By Fast one

It's a closed system so the level should remain...

It's a closed system so the level should remain the same as when it was filled, I would suggest changing the fluid and filter more often and use a 12 volt transfer pump to speed up the process.
Forum: C5 Tech
03-13-2024, 03:02 PM
Replies: 22
Views: 536
Posted By Fast one

Last year I installed a Melling 10296 with the...

Last year I installed a Melling 10296 with the blue spring and the oil pressure is very good for a 130,000 mile engine, however it isn't raced. A Cloyes 9-3658TX3Z timing set was also used and it's...
Forum: Testing
03-13-2024, 02:49 PM
Replies: 0
Views: 107
Posted By Fast one

test 25

https://duckduckgo.com/?va=e&t=hq&q=powel+machine+oil+pump+video&iax=videos&ia=videos&iai=https%3A%2F%2Fwww.youtube.com%2Fwatch%3Fv%3DUhqbBE8gzrM
Forum: C5 Tech
03-05-2024, 09:37 AM
Replies: 4
Views: 178
Posted By Fast one

Many thanks for the reply, the new sensor is...

Many thanks for the reply, the new sensor is going in today.
Forum: Testing
03-04-2024, 08:46 PM
Replies: 0
Views: 151
Posted By Fast one

test 23

https://cimg2.ibsrv.net/gimg/www.corvetteforum.com-vbulletin/2000x1504/img_1655_3602165e2d732274d4c4be0af6939afe98cd4d7c.jpeg
Forum: C5 Tech
03-04-2024, 04:19 PM
Replies: 4
Views: 178
Posted By Fast one

Does the crankshaft position sensor need spacers?

I measured the clearance to be 0.004" between the end of the new sensor and the OD of the reluctor wheel. Should there be more space between the two or doesn't it matter?
Forum: C5 General
03-04-2024, 12:08 PM
Replies: 8
Views: 360
Posted By Fast one

The second last post here is why I...

The second last post here is why I asked:https://www.corvetteforum.com/forums/c5-tech/4286512-dreaded-pull-key-wait-10-seconds-after-lmc5-install.html
Forum: C5 General
03-04-2024, 11:04 AM
Replies: 8
Views: 360
Posted By Fast one

Do you have to allow the gages to set in the...

Do you have to allow the gages to set in the ignition position before engaging the starter as others have had to do?
Forum: C5 General
03-04-2024, 11:00 AM
Replies: 29
Views: 948
Posted By Fast one

The original still works in the 130,000 mile '98...

The original still works in the 130,000 mile '98 and it's seen a lot of lot miles with almost empty tanks (ran out twice) but the fuel filters have been changed four times and now it's kept at half...
Forum: C5 General
03-03-2024, 05:13 PM
Replies: 452
Views: 27,015
Posted By Fast one

Thanks, that's what I needed to know.

Thanks, that's what I needed to know.
Showing results 1 to 25 of 205
 
Page 1 of 9
1
2
3
Last »


 
Forum Jump

Trending Topics

All times are GMT -4. The time now is 10:41 PM.