Vindicator cam kit new in box
 

I have a brand new unused unopened cam kit from vengeance racing. specs are... 240/244 .608/.596 112+4.
This is the complete kit with pushrods , dual springs ,seals ,seats and the cam itself. Ill take 650 shipped. After shipping and tax it was almost 800 new for questions text 706-618-5311

Bump

Bump

Very Nice!! Good price as well...

Not sure on how to read the spec but I have an 03 z06 will it fit and if so will it be a rough drive for an everyday car?

. This is a clip of a friends car 01 z06 with the vindicator cam. He says it wasn't bad at all to drive for the idle to be so choppy.

Bump

What kind of power did it make?

Did you friend install it with stock heads. The lift seems a little high but I was just wondering? What brand are the push rods and springs and do they come with locks and retainers

Yes his had stock 243s and ill have to ask what kind of power he made. I think it was a little above 400

The kit is straight from vengeance so it is what they supply . They are the dual springs and hardened pushrods is all the website says

Bump he made 432 rwhp at vengeance

Bump

Bump for 650 obo shipped! Am I overpriced for a brand new kit?

Will this work w/ a stock LS1?

Yes it sure will

Saturday ttt

I have this cam in a 2000 LS1 with 243 heads, Fast 92, 3:90 gears and the car made 441/415 on Vengeance dyno. It's a beast! If you have any questions on the cam, contact Ron or the guys over at Vengeance.. they will be happy to answer anything I'm sure! :cheers:

How many miles are on it? How will this work with an A&A kit with a 3.73A4 running through Kooks 1-7/8"Catted headers feeding a Looks 2-1/2" or 3" X-pipe running into a Corsa Xtreem axle back on Patriot heads?

This cam is brand new In the box. I would say this cam would work with a blower but it would bleed off a little boost I'm sure. Maybe someone with more knowledge can step in and confirm or deny thanks