Save Your Rockers For Only $55.00 Shipped ....ends Friday

[E.C.P]

AS SEEN AND TESTED ON CORVETTEFORUM.COM THE ULTIMATE IN PROTECTION FOR YOUR 97-07 C5/C6 CORVETTE Steep driveways and speed bumps can be hazardous, not to mention costly to the rockers on your Corvette.If your Corvette is lowered the constant worry of wrecking your expensive rockers is enough to drive you mad. Here at last is a well though out product designed and tested by a Corvette owner. My "ROCKER SAVERS" are made from an ULTRA HIGH MOLECULAR WEIGHT material that is" EXTREMELY RESISTANT TO ABRASTION...HAS A VERY LOW COEFFICIENT OF FRICTION SELF LUBRICATING / NON -TOXIC / EXTREMELY LIGHT [less than 1lbs for both peices] IMPACT / VIBRATION / UV / AND CORROSION RESISTANT EVEN IN CRYOGENIC CONDITIONS . Unlike powder coated aluminum that will flake at the first contact it has with a speed bump the colour of my product will always be there.Unlike aluminum that does not stand up well to asphalt and concrete, this material will not wear. Easy to install ,about an hour. Includes all stainless steel hardware & step by step installation instructions. Best of all you can still use your jacking pucks.The "ROCKER SAVERS' give you a 1/2" buffer zone between them and your expensive rockers. PRICED PER PAIR @ $62.00 shipped anywhere in N.America. OPENING SPECIAL $55.00 A PAIR FOR THE MONTH OF AUGUST. Fits both C5 or C6 including Z06 . PAYPAL TO nastyvette@sympatico.ca WILL FIT VETTE'S WITH ACI ROCKERS Instructions for the ROCKER SAVERS : ROCKER SAVERS INSTALLATION INSTRUCTIONS; Tools needed; 13mm socket 5mm Allen key 5/32” drill bit Phillips bit screw driver or bit Hammer & punch 1. Locate the factory bolt just behind the rear shipping slot. 2. This bolt holds the rear aluminum shield. Remove this bolt. 3. Take the rail marked “DRIVER”. The largest of the four holes is your rear location hole. 4. Place the rail up to the hole where you removed the 13mm hex head bolt from and insert the supplied new 5mm Allen head bolt. We recommend LOCTITE on all the bolts and screws 5. Tighten until its snug. 6. Line up the rest of the rail, making sure you are not up against the rocker its self. 7. Once you are satisfied with your placement, remove the tape cover from the two way tape at the front edge, and press firmly into place. 8. Using a hammer and punch mark the 3 remaining holes and drill with a 5/32”drill bit. 9. Insert the 3 remaining SS screws and tighten starting from the SS 5mm Allen head through to the last SS Philips head screw. 10. Repeat same procedure on the passenger side. ROCKER SAVERS BY ENGINEERED CORVETTE PRODUCTS Thanks for all your support . Manny Dasilva Engineered Corvette Products

[E.C.P]

Ttt