CorvetteForum - Chevrolet Corvette Forum Discussion


ArKay99 ArKay99 is offline

Safety Car

Last Activity: 11-07-2019 06:16 PM

About Me

  • About ArKay99
    Name
    Roger S. Keay
    Location
    Cape Coral FL
    Occupation
    Software Engineer
    Year & Model
    1999 Hardtop
    Color
    Pewter
    Mods
    All Kinds
    Country of Residence
    US
  • Signature

    Go: LPE 403, VaraRam+Haltech, Tony Mamo ported FAST90/NW90, Kooks 1 7/8 x 3", Ti's, Ripper, 4:10's, DTE Brace, Tex 0Z700, QA1's, Tony Mamo ported AFR 205's, Comp 242/242 .610/.610 114LSA+2, Yella Terra's, 42lb inj, ASP pulley

    Show: Euro tails & mrkrs, Z06 chromes/Pilots, Torch Red/Blk interior, 300Wx2 Bolt w/12" Sub, red calipers, black rear letters, Zaino.
    New motor 530 RWHP, 480 RWTQ

Statistics

Total Posts
Visitor Messages
Total Likes
General Information
  • Last Activity: 11-07-2019 06:16 PM
  • Member Since: 09-13-2003

Friends

Showing Friends 1 to 3 of 3

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. ArKay99
    11-05-2010 09:43 AM
    Thanks for the advice. Off to Harbor Freight.
  2. Allthrottleandsomebottle
    11-05-2010 08:33 AM
    You will need a large set of c ring pliers..........no way around it:
    http://forums.corvetteforum.com/phot...-4-06_0004.jpg
    http://forums.corvetteforum.com/phot...-4-06_0003.jpg
    As for the balance, IMHO I would take it to a drive shaft shop and have them check it. 4x4 shop may be helpfull.
    Good luck!
    Steve
Trending Topics

All times are GMT -4. The time now is 01:25 PM.