Anthony,


I bought some G2 coil overs from you last year for a C6Z race car, can you send me the setup specs again? Castor, camber, and toe?


Thanks,

Anthony, got a quick question for you guys. Whats typically the spring rate for your LG GT2s for C6Z? I bought a set from you guys about a year ago and cant find any spec for spring rates anywhere. Do you guys do revalve jobs if I wanted to go stiffer springs? Thanks, just shoot me a PM back when you can.

Please pm a price for a set of the G2 coil overs for an 07 Z06. Buddy from Fla said you'll do the best price Thanks. Shipped to 12538

Anthony - have you mailed the rubber bumpers for my hood?


Kevin Kohlscheen

The corner of my CF hood nearest the windshield on the drivers side sticks up higher than the fender? Any ideas on how to adjust it? There are also a couple of cloudy spots that appear to be in the clear coat. Any ideas on that?

Thanks

Kevin Kohlscheen[/QUOTE]

Make sure you use some kind of wax or polish with a uv protectant...I think Zanio does and other similar products do as well.

for the corner....the carbon, or real carbon, per say will move around a bit and can change with temp..is this something that moves a bit with heat? Wonder if it did it while it was outside here? At any rant on some of the cars I have had to run a small rubber "bumper" so to speak about half way up the fender to cause the hood to bow a little bit to match the fender line which would typically bring that down...if I am right it is probably a little flat about half way up the fender?

What would the price be with the quite endlinks?

Testin testing... Anthony are you okay?

Do you have any of take off stock c6 z06 fascias lying around at the shop? My wife took mine out on a curb parking.

Hello Anthony, I installed a LG cam and I needed the specs on it for a new head setup.
The cam G7X5
If you could pm or email those specs I would greatly appreciate it!
email: miasma19@gmail.com
Thank you sir
Matt

Anthony can you please send me a PDF file for the instructions on the G2 coilover installation. I purchased from TPS and I did not receive anything with instructions. I;m having a nightmare of a time installing the rear coilovers and I'm a bit confused on how exactly they bolt up to the upper frame on a C5. It seems as if the coil spring will hit the axle shaft boot and rear tie rod. The bracket is offset and I just really need some good pictures if you have them to properly show me how to do it. You can PM me or my email is revhardsi@yahoo.com

thank you so much

Clear out your inbox