Painted Roof Adhesive Separation - 2005/2006 Corvette Coupe-REVISED

[Ken Fichtner]

Subject: 05112A – Customer Satisfaction Program Painted Roof Adhesive Separation Service Procedure Revised

Message #: WIR20060275

GM SERVICE AND PARTS OPERATIONS
DCS1528
URGENT - DISTRIBUTE IMMEDIATELY

Date: February 23, 2006

Subject: 05112A – Customer Satisfaction Program
Painted Roof Adhesive Separation
Service Procedure Revised

Models: 2005-2006 Chevrolet Corvette with Painted Roof

To: All Chevrolet Dealers

Attention: Service Manager, Parts Manager
and Warranty Administrator


Customer Satisfaction Program Bulletin 05112 was released on February 21, 2006 via GM Administrative Message WIR20060273.

Please be advised that Steps 3 and 23 in the service procedure have been revised. A copy of revised bulletin 05112A is attached below. Please discard all copies of bulletin 05112.

The Service Information System (SI) version of this bulletin will reflect this change in the near future.

Please review the revised procedure immediately and make sure that all affected service personnel are aware of this revision.

Click here for the bulletin and for the complete VIN list:

http://temp.corvetteforum.net/c5/ken...onbulletin.pdf

[Shawn S]

My 2006 is well above that VIN range, but it’s making the same type of “Styrofoam squeak-snap-pop” sound described in the recall.
Production date was 12/15/05 and the VIN ends with 65112XXX

[AFVETTE]

Ken, appreciate the info. I have been following these threads very closely as my 06 Coupe goes into production this week (TPW 2/27/06). My car was ordered ONLY with the solid panel, so if mine should fail that could be more problematic for folks like me.

I sure hope the targa top they install on a car being manufactured AFTER the problem has been officially recognized won't be afflicted with this problem. I'll be a very unhappy camper if my targa should fail this late into the 06 production cycle.

Cheers

Tom

[2005ArcticWhite]

Very good information