580 inch engine from MTI Racing, Marietta, GA
09-21-2010, 04:20 PM
#1
Former Vendor
Thread Starter
580 inch engine from MTI Racing, Marietta, GA
MTI Racing has its own in-house machine shop called MTI Machine.
All honing, boring, balancing, crank turning, and cylinder head machining is done on site. Over the past year, we have built some very powerful combinations for street and racing. We are not limited to machining only GM.
Over the last year we have built GM, Mopar, Ford, Mercedes, Honda, and Nissan engines for shops and individuals. We even refreshed a John Deere Tractor Pulling Engine.
Here is a 580 cu.in. HEMI that was built for a really angry Road Runner. Check out those massive cylinder heads and valve covers!!
For the racing crowd, we can also build Ford up to 747 cu.in. and Mopar up to 615 cu.in.
For more information, you can call our machinist David on his direct line at (770) 919-7788.
All honing, boring, balancing, crank turning, and cylinder head machining is done on site. Over the past year, we have built some very powerful combinations for street and racing. We are not limited to machining only GM.
Over the last year we have built GM, Mopar, Ford, Mercedes, Honda, and Nissan engines for shops and individuals. We even refreshed a John Deere Tractor Pulling Engine.
Here is a 580 cu.in. HEMI that was built for a really angry Road Runner. Check out those massive cylinder heads and valve covers!!
For the racing crowd, we can also build Ford up to 747 cu.in. and Mopar up to 615 cu.in.
For more information, you can call our machinist David on his direct line at (770) 919-7788.
