Racer2B

This stuff looks pretty good, I might get the GP chair, anyone else have any of this stuff?...I remember when there was a Recaro and Sabelt version, but they were just reclinable seats with plastic bases. This stuff looks pretty detailed and is priced pretty well.

HERE

knyght4

I'm not entirely sure I understand how the table works.

Racer2B

I don't think its supposed to "work"...it just IS

The shocks are for looks, but the wing will give you some good downforce while drafting up your documents haha

SIK02SS

All show no go

OKsweetrides

Hmmm... that chair has given me some inspiration.
Stock C5Z seats with 40 miles + Supra Coilovers + C5Z wheels = Barstools!

Grrr... need to finish up the clock I'm making with a Ferrari CCM caliper/hub/wheel off a California.

Racer2B

Nice. I made a table out of a busted STI rim for a kitchen bar table. Welded up a frame with some foot rests, got a glass top for $50 from Pier1...it even attaches with lugs to the frame!

AU N EGL

There are a few guys with blown engine blocks that are used for coffee table bases.

TmillerC5

How about a nice cam light

[IMG][/IMG]

shakedown067

The desk is the best use of a wing ever...when not on an actual race car.

Gary04Z06

Nice! Been wanting to do that soon.

RedLS1GTO

I have a coffee table using the same basic theory except it uses an old Dale Earnhardt tire that I got when I was a kid at a race.

Racer2B

I also have two M3 front seats converted into a fully functioning 4-way adjustable "love seat"...original plans were to use it for a 2 player simulator...still a possibility.

dvandentop

that cam light is awesome, might have to try that one out

rag1998

How were you able to get the power seats to work?

Would love to do something like that..


The Cam light & the table are awesome..need to clean up some of my old tires & make a table..

Racer2B

Very easy...get some 3 way momentary switches, connected them to a battery...done

They move forward/back, recline up/down, seat goes up/down in front, seat goes up/down in rear. Only thing I could not get to work was the lumbar support inflation system...this was because I ripped it apart when uninstalling the seat from the car it came out of that was being converted into a full racecar.

Here are the seat and the center control panel...welded steel frame:

Timz06

There was a post a long time ago where a guy had a table made from c4 wheels, and another table that had a c4 zr1 engine enclosed in glass.