QwickerRon

I am installing new harness' in my Z. I need a bar that installs on the seat bolts and has three holes drilled into the bar for lap belt and/or sub belt. The bar is the width of the seat rails and is bent so the bolts that hold the belts is elevated about 1" from the floor. I have one of these bars but need three more. I have searched the internet and local racing parts houses but can't locate them. Any ideas out there?

JDIllon

Dan, at vetteworks http://www.vetteworksonline.com/cata...1aa309f40d0ba4
or
Gary at Hardbar http://www.hardbarusa.com/hardbar/

JD

Bill Dearborn

You do not want the first one shown. That one mounts the sub belt in front of the seat which is worse than not using the sub belt at all.

Bill

JDIllon

I Think if you check with Dan at vetteworks, it mounts behind the seat not in front. JD

QwickerRon

So you're suggesting bolting the lap belt and sub belt on the bar on the rear of the seat and pulling sub belt through gap of seat back and seat?

Lancer033

the lap-belt bar (3rd item on the 1st link) has a place to hook in both the lap belts and sub belts in the right location.

Skip the 5-point deal unless you've got a proper racing seat with a hole in the bottom

MatthewR

I've got an extra one, hardly used and will sell for $50 shipped. Used it 3 or 4 weekends on my 2007 Z06. It is a balck piece of heavy steel that bolts down between the back seat track bolts on a C5 or C6. The lap belts clip into eye bolts and the anti-sub staps feed through triangular clips w/ belt slots.

Best,
Matthew Rogers
mrogers@cbmlaw.com
213 833 4504