Suntek PPF Installation Issue Questions
#1
Safety Car
Thread Starter
Member Since: Aug 2005
Location: Eastern NC; Retired x 2 (US Army: 70-90 AD) (US Army: 91-16 DAC); yea, I'm old.
Posts: 4,278
Received 76 Likes
on
42 Posts
Suntek PPF Installation Issue Questions
I had pre-cut sections Suntek PPF installed on the front bumper on Monday and when I picked the car up, I notice what appeared to be bubbles at the top edge under the headlight.
When I pointed it out, the installer said it was solution and would dry up. I accepted the explanation and parked the car facing the NC afternoon sun thinking it would speed up the drying. It is probably paranoid on my part but I have repositioned the car daily for maximum sun exposure since then and nothing has changed. Yesterday, while looking closer, I found a lot more “bubbles” (see below).
How long should I wait to take it back to the installer and what should they do to fix it.
When I pointed it out, the installer said it was solution and would dry up. I accepted the explanation and parked the car facing the NC afternoon sun thinking it would speed up the drying. It is probably paranoid on my part but I have repositioned the car daily for maximum sun exposure since then and nothing has changed. Yesterday, while looking closer, I found a lot more “bubbles” (see below).
How long should I wait to take it back to the installer and what should they do to fix it.
#3
Team Owner
The following users liked this post:
BudgetPlan1 (06-08-2019)
#4
Safety Car
Thread Starter
Member Since: Aug 2005
Location: Eastern NC; Retired x 2 (US Army: 70-90 AD) (US Army: 91-16 DAC); yea, I'm old.
Posts: 4,278
Received 76 Likes
on
42 Posts