$999 shipped for C7 splitter AND rocker blades!!!
#1
Safety Car
Thread Starter
Member Since: Jan 2012
Location: Cin City
Posts: 4,885
Received 481 Likes
on
317 Posts
St. Jude Donor '14
$999 shipped for C7 splitter AND rocker blades!!!
We're running a special on our carbon splitter and rocker blades. These are American made and priced so competitively that even our carbon fiber rivals most fiberglass kits! They're made from the same molds and come gel coated ready to prep and paint. They use OEM mounting locations as well!
Composite splitters and rocker blades are $999 shipped!
Carbon Fiber with clear coat are $1499 shipped!
Splitter - It has a nice lip across the front that tapers up and angles downward between the two fins on the lower front bumper lip so there's no awkward flat step up to try and bridge the gap. This space between the fins also provides some driveway relief! I know a couple of you guys were worried about the winglets on the side. They're in line with the tires and they're very short, so they blend in very well, but really draw some nice attention as well! It uses all OEM mounting bolt holes and if present, you can reattach your air deflectors under them if you wish.
Rocker blades - These run wheel to wheel and don't flare out until past the door line. We did this not only for style but to also keep the road rash off the bulging rear fenders. Again, these use all OEM bolt hole for mounting.
Enjoy the pics!
Notice the splitter and hood profile
side profile of splitter, rockers, and spoiler
Check out the splitter and hood profile!
The END
Composite splitters and rocker blades are $999 shipped!
Carbon Fiber with clear coat are $1499 shipped!
Splitter - It has a nice lip across the front that tapers up and angles downward between the two fins on the lower front bumper lip so there's no awkward flat step up to try and bridge the gap. This space between the fins also provides some driveway relief! I know a couple of you guys were worried about the winglets on the side. They're in line with the tires and they're very short, so they blend in very well, but really draw some nice attention as well! It uses all OEM mounting bolt holes and if present, you can reattach your air deflectors under them if you wish.
Rocker blades - These run wheel to wheel and don't flare out until past the door line. We did this not only for style but to also keep the road rash off the bulging rear fenders. Again, these use all OEM bolt hole for mounting.
Enjoy the pics!
Notice the splitter and hood profile
side profile of splitter, rockers, and spoiler
Check out the splitter and hood profile!
The END
#3
Le Mans Master
Will you have them for the base Z06?
#10
Splitter and blades
Hello! DO you still have the special? If so whats the shipping cost to El Paso Texas? When I will have them on my door?? OHH by the way what is the color for the $999 option.
Thanks
Best
ERM
Thanks
Best
ERM
Last edited by ERM; 09-01-2014 at 07:14 PM.
#12
Racer
#13
Safety Car
Thread Starter
Member Since: Jan 2012
Location: Cin City
Posts: 4,885
Received 481 Likes
on
317 Posts
St. Jude Donor '14
Yes guys these are all available separately. This is an old sales thread though. The $999 was for unpainted composite parts.
I do have a set of RPI carbon flash splitter and rockers in stock that I can do $999 shipped though
I do have a set of RPI carbon flash splitter and rockers in stock that I can do $999 shipped though