0corvettemods1

As many of you know, you risk damaging your Corvette when you or a shop tries to lift it without have proper jack pads in place. Why take the risk of getting your prized possesion back with damaged rockers?

Our new, lightweight ABS plastic Jack Pucks will save you the aggrevation and you'll know they are always there. Take it to the dealer, a performance shop or the tire shop without worries. You'll always have these pucks ready to protect, invisible to everyone!


Sold as a set of 4, we have these marked down to:

$49.99 A SET!

Click here to order:
http://www.corvettemods.com/Corvette...R-_p_9265.html

gkwpnut

They go in easy and look good and nice people to work with.

Zmoy2

Are they specifically for the c7? They won't fall off or interfere with the body panels?

0corvettemods1

Correct, tons of reviews on the forum about our part too.

Shortimer

Installed a set and walked away. They work great and can't be seen unless you get down low and look for them. I'll post photos shortly.

Here you go:

beachcomber

Bought a set from you as well. Couldn't be happier! Easy to install, stays solidly in place and is hidden. Would buy again!

NTMD8R

How do they actually fasten in ?
And, are you sure they won't come out on their own ?????

Being plastic, are they really strong enough to support 900 to 1000 lbs ?

0corvettemods1

they are pressure fit pucks. They are built for the sole purpose of jacking up a car

CONMAX

will these work on the z06? i realize that the aero is in the way of even geeting a low profile jack under the car. i use a ramp to get it part way up b4 jacking, so only the frame hole where they insert may be an issue.

0corvettemods1

We haven't tested it yet. If you have an unobstructed area where they attach it should work fine

slownlo

are they easy to remove if needed?

0corvettemods1

Absolutely

oldfoggy

sorry to be an **** pain . . . . do they fit the with the stage 3 side skirts?

Thanks, had them on my 2014 Z51 and loved them.

0corvettemods1

they will