When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Mine was $5,500, but that included the custom design. They will vary depending on the quality of the material, custom design, colors...
PPF is definitely worth it, wraps are not indestructible. I've had mine on my Z06 for almost 2 years now, with no PPF. I don't DD her, but with almost 20k miles since I had the wrap installed, it's showing some wear and tear. There are several places where the vinyl has been pot marked, though it doesn't look like the damage was enough to harm the paint under it. When I get her wrapped again, I'll definitely cough up the extra $$$ for PPF on the high impact areas.
I'm not saying vinyl is the same as PPF, I just do not see the point to it unless like I said above you plan on keeping the wrap for a long time. Then go for it. I've never done it that way, never will, but everyone sees value of PPF differently. To each their own, and own money spent.
Hey guys. Do they do the jams also? If so how’s it look? Would think that would be a pia.
It is a PIA and no they don't normally do the door jams - too many small breaks would be required. I have helped a friend who owns a wrapping business and the worst is going from a white car to all black. Great looking cars guys!
Hey guys. Do they do the jams also? If so how’s it look? Would think that would be a pia.
Like the other two said, they will, but it will cost you. I'm lucky and my car is black, and black goes with anything so the door jams not being done still looks good. It's something to think about when choosing your wrap for sure.
Bought it with 75% coverage of clear PPF plus the red stripe on the side skirts. Completed to 90% by putting it on the tonneau cover and trunk. Not worried about the butt end!
What flooring is this? I'm looking to epoxy my garage but this looks interesting.
That is Racedeck Flooring and they do Custom designs. It is easier on the fet and will handle a load up to 19.000 PSI I and a buddy did a 15 by 45 garage in about 2.5 hours. A table saw is great for the corners. You can mount a carlift on top of it. Sheet coveers a 65 inch TV that only picks up Car Racing.
05-21-2021, 04:58 PM
