Under Hood and other Mods
#1
Instructor
Thread Starter
Under Hood and other Mods
I just installed the APR carbon fiber plenum and fuel rail covers custom painted from RPI. Other minor mods: Lloyd custom mats front and back, OEM splash guards, OEM Mobile 1 oil cap, Corvette tire valve stem caps.
Last edited by Rusty67; 11-11-2020 at 12:06 AM.
#3
Le Mans Master
Looks good!
#5
Instructor
Thread Starter
#7
Le Mans Master
Good Start
#8
#11
Melting Slicks
Pete at Showstoppers did these. The fuel rail covers are black with silver and gold airbrushing. The plenum if carbon flash. This is on a black Z51.
The following users liked this post:
Godsvett (06-25-2018)
#13
Instructor
Thread Starter
#14
Team Owner
Member Since: Oct 2013
Location: Kansas City, Missouri
Posts: 25,391
Received 7,767 Likes
on
4,190 Posts
CORVETTE TODAY Host
St. Jude Donor'15
All of these look great!
#15
Racer
They all look good here's a poor man's setup took about 3 hours but doesn't look to terrible I hand painted the corvette logos
Used high temp paint black for the plenium cover and tension blue for the covers and fuse box
Used high temp paint black for the plenium cover and tension blue for the covers and fuse box
The following users liked this post:
Bob Beroza (06-24-2018)
#16
All your stuff looks really nice. I did my engine compartment with stainless steel from American Car Craft. That took a a while to install.
#17
That blue color really pops!! For a poor man's job it looks good to me.
#19
Racer
Thanks I was looking at other options and saw where people had done the cowl or heat extractor so I went out this morning and did mine now I'm wondering if I should do the lower half also
#20
Instructor
Thread Starter