total cost to have SC installed on C7 ?
#1
total cost to have SC installed on C7 ?
Just upgraded to a z51 auto C7 from a C5 with Maggie. I'm going to be looking at a SC to up the power.
Daily driver and want it to stay that way! At this point I'm trying to see an estimate on total cost including install.
No looking for a dyno queen but great drivability and reliability.
I live in Myrtle Beach, SC so not sure of shops or labor rates
Suggestions???
Daily driver and want it to stay that way! At this point I'm trying to see an estimate on total cost including install.
No looking for a dyno queen but great drivability and reliability.
I live in Myrtle Beach, SC so not sure of shops or labor rates
Suggestions???
#2
Intermediate
I’m finishing up a Magnuson 2650 install right now on my 2016 Z51 Stingray. I’ve got roughly 22-23 hours into it and have approximately another 1-2 hours to go.
So while I don’t know the answer to your exact question, it gives you an idea on what it would cost based on a known hourly shop rate.
So while I don’t know the answer to your exact question, it gives you an idea on what it would cost based on a known hourly shop rate.
#3
The numbers will be all over the place. I don't want to say names, but they build centrifugal superchargers, and they mentioned something about $2000 installed and tuned. This was a year ago. The kit is roughly $6500.
#4
Le Mans Master
Most shops are 1500-2000 for a blower install not including tuning.
The following users liked this post:
Josh@AandASuperchargers (11-10-2023)
#5
Race Director
I’ve seen installed edlebrock for between 8 and ten I can’t remember the exact number as it’s been awhile.
for a daily driver I’d pass on the headers myself to hold the power to 100 or 150 more than stock usually with a local tune.
some guys want the most Hp whereas I would personally prefer stock durability and minimal extra service requirements.
550 or 600 hp for a stock corvette drivetrain is more than enough extra for a street car.
for a daily driver I’d pass on the headers myself to hold the power to 100 or 150 more than stock usually with a local tune.
some guys want the most Hp whereas I would personally prefer stock durability and minimal extra service requirements.
550 or 600 hp for a stock corvette drivetrain is more than enough extra for a street car.
#6
Supporting Vendor
Just upgraded to a z51 auto C7 from a C5 with Maggie. I'm going to be looking at a SC to up the power.
Daily driver and want it to stay that way! At this point I'm trying to see an estimate on total cost including install.
No looking for a dyno queen but great drivability and reliability.
I live in Myrtle Beach, SC so not sure of shops or labor rates
Suggestions???
Daily driver and want it to stay that way! At this point I'm trying to see an estimate on total cost including install.
No looking for a dyno queen but great drivability and reliability.
I live in Myrtle Beach, SC so not sure of shops or labor rates
Suggestions???
Just giving you something to chew on in regards to what we would be.
__________________
Cordes Performance Racing aka "CPR"
Owner of AZ's premier LSX/LTX motorsports shop
http://cordesperformanceracing.com/
www.facebook.com/cordesperformanceracing.com
joe@cordesperformanceracing.com
480-359-5914
Cordes Performance Racing aka "CPR"
Owner of AZ's premier LSX/LTX motorsports shop
http://cordesperformanceracing.com/
www.facebook.com/cordesperformanceracing.com
joe@cordesperformanceracing.com
480-359-5914
The following 4 users liked this post by Cordes Performance Racing:
dankhts (11-10-2023),
JerriVette (11-08-2023),
Jims Z06 (11-24-2023),
Josh@AandASuperchargers (11-10-2023)
#7
If you did say a Magnuson kit (more time to install than a A&A or procharger) we would be $2170 to install, plus spark plugs, fluids, tune. That's 14 hours @ $155/hr. Tune would be $650 plus credits if you are a 16+. Than add on the kit itself. If it was a centri blower kit labor would be $310 less.
Just giving you something to chew on in regards to what we would be.
Just giving you something to chew on in regards to what we would be.
The following 3 users liked this post by Tristen1963:
#8
When I was going down the path of upgrades, I can say Cordes prices were more than competitive and I see cars in the Phoenix area that use them with high praise.
If you do some search, you can see and find what other people think. I would just say don’t equate cost with quality. Do research and reach out and make contact. It will give you an idea what service and support would be like after.
If you do some search, you can see and find what other people think. I would just say don’t equate cost with quality. Do research and reach out and make contact. It will give you an idea what service and support would be like after.
The following 2 users liked this post by Pktrusty:
Cordes Performance Racing (11-28-2023),
Jims Z06 (11-29-2023)
#9
Advanced
Just upgraded to a z51 auto C7 from a C5 with Maggie. I'm going to be looking at a SC to up the power.
Daily driver and want it to stay that way! At this point I'm trying to see an estimate on total cost including install.
No looking for a dyno queen but great drivability and reliability.
I live in Myrtle Beach, SC so not sure of shops or labor rates
Suggestions???
Daily driver and want it to stay that way! At this point I'm trying to see an estimate on total cost including install.
No looking for a dyno queen but great drivability and reliability.
I live in Myrtle Beach, SC so not sure of shops or labor rates
Suggestions???