[Z06] Finally got around to share my dyno results
#1
Racer
Thread Starter
Member Since: Jul 2007
Location: Texarkana Arkansas
Posts: 421
Likes: 0
Received 0 Likes
on
0 Posts
Finally got around to share my dyno results
First off let me say thanks to quality motorsports in dfw Texas. Patrick,Ethan,Doug are great guys and provided exceptional customer service and will have my business on my Z. Well after getting my heads in From WCCH (which looked great) the guys put everything on and fired her up. Car had a bad 02 sensor, replaced that and loaded base tune, strapped to dyno. Turns out gas was old/bad was pulling timing or whatever (car had been sitting for about three months with same 3/8 tank when I bought it. After doing several pulls best run was at 560/481. Most Z with same mods usually 575-580hp. I was a little disappointed but car drives great and still hauls *** but I'll be back for more hp as I'm thinking about changing CAI to halltech and adding a FAST intake and TB.
My mods: xxcelerator CAI, AR long tubes, muffler mod, WCCH stage 2 heads ported and milled with upgraded valves, Harland sharp rocker arms, custom hardend push rods, QM stage 4 street cam, ported TB and Intake, 160* and 20x10f and 20x13r forged wheels 285/345 invos
My mods: xxcelerator CAI, AR long tubes, muffler mod, WCCH stage 2 heads ported and milled with upgraded valves, Harland sharp rocker arms, custom hardend push rods, QM stage 4 street cam, ported TB and Intake, 160* and 20x10f and 20x13r forged wheels 285/345 invos
#3
Racer
Thread Starter
Member Since: Jul 2007
Location: Texarkana Arkansas
Posts: 421
Likes: 0
Received 0 Likes
on
0 Posts
#5
Racer
Thread Starter
Member Since: Jul 2007
Location: Texarkana Arkansas
Posts: 421
Likes: 0
Received 0 Likes
on
0 Posts
Yeah QM told me that the big wheels will hurt the numbers a little. Has anyone on here switched from a xxcelerator CAI (Calloway style) to halltech and seen any improvement?