[Z06] Dewitts dual fan install - wiring
05-20-2012, 12:19 PM
#1
Burning Brakes
Thread Starter
Dewitts dual fan install - wiring
Just installed the fans and now want to make sure I'm wiring properly - is everyone still using the factory controller, then splicing together the power and ground as seen in pic?
Was going to solder these together then plug into the fans harness.
Thanks
Was going to solder these together then plug into the fans harness.
Thanks
05-21-2012, 11:59 AM
#2
Safety Car
Member Since: Aug 2006
Location: Apache Junction AZ
Posts: 4,347
Likes: 0
Received 22 Likes
on
18 Posts
I used heat shrink butt crimps. They melt to make an air tight seal around the wire insulation. Got them at Harbor Freight.
BJK
BJK
Last edited by 07MontRedcp; 05-21-2012 at 12:01 PM.
05-21-2012, 01:46 PM
#3
Burning Brakes
Thread Starter
