Master Cylinder Replacement Question > Retaining Clip on Connector
04-22-2014, 08:02 PM
#1
Pro
Thread Starter
Member Since: Sep 2009
Location: South of I-64 Illinois
Posts: 515
Likes: 0
Received 0 Likes
on
0 Posts
Master Cylinder Replacement Question > Retaining Clip on Connector
Can anyone offer a tip on getting the master cylinder connected up to the slave cylinder?
For the life of me I cannot get the connection together--there isn't an apparent 'lock' between the connectors and GM used a forked metal retaining clip. Due to the placement, I don't have enough hands or leverage to hold the master/slave connector together while putting the retaining clip in place. Is there a trick or a special tool?
For the life of me I cannot get the connection together--there isn't an apparent 'lock' between the connectors and GM used a forked metal retaining clip. Due to the placement, I don't have enough hands or leverage to hold the master/slave connector together while putting the retaining clip in place. Is there a trick or a special tool?
