Question about headers
#1
Melting Slicks
Thread Starter
Question about headers
So, I am considering going with some LT headers and I have a few questions. I am looking for the best possible sound with my current BB Fusion axle back exhaust.
Should I go with 1 7/8 or 1 3/4?
Cats or no cats?
Do I need to change the mid pipe?
Should I have them coated to protect against heat?
Are there any other mods necessary or recommended when doing headers besides a tune?
I am probably going to go with LG/Kooks/AR - Any benefit of one over the other?
Again, I am looking for a setup with the best sound and not as concerned with ultimate HP. I am assuming I will be in the 480whp range regardless?
Thanks for the help guys!
Should I go with 1 7/8 or 1 3/4?
Cats or no cats?
Do I need to change the mid pipe?
Should I have them coated to protect against heat?
Are there any other mods necessary or recommended when doing headers besides a tune?
I am probably going to go with LG/Kooks/AR - Any benefit of one over the other?
Again, I am looking for a setup with the best sound and not as concerned with ultimate HP. I am assuming I will be in the 480whp range regardless?
Thanks for the help guys!
Last edited by bigterpsfan; 07-16-2011 at 05:48 AM.
The following users liked this post:
2FAST4U (09-07-2022)
#6
Melting Slicks
Thread Starter