WTB: 2'' headers
#1
Le Mans Master
Thread Starter
WTB: 2'' headers
Like the title says. Need to be Z06/ZR1 style
Last edited by whatcop?; 04-18-2014 at 12:02 AM.
#7
I just pulled some off my 2012 ZR1. ARH with 2" ( 1" = 2.54 cm. 2 x 2.54 x 3.14 = 15.95 cm circumference as shown in pic. ) primaries. No cats. Looking to sell them. Gaskets, clamps, bolts/nuts/washers and O2-sensor extensions included. Located in New Hampshire. Will ship as needed.
One of the primaries had to be slightly modified to clear the steering linkage as pictured. ARH said the 2" primaries should fit but no amount of adjusting would prevent the one driver's side primary from contacting the steering linkage. Motor vibration could be felt through the steering wheel; especially, when making right-hand turns. I pulled the header and forced a small dent, reinstalled the header and all was well.
One of the primaries had to be slightly modified to clear the steering linkage as pictured. ARH said the 2" primaries should fit but no amount of adjusting would prevent the one driver's side primary from contacting the steering linkage. Motor vibration could be felt through the steering wheel; especially, when making right-hand turns. I pulled the header and forced a small dent, reinstalled the header and all was well.
#9
Premium Supporting Vendor
ARH 2" will fit with steering shaft clearance.
If there is ever a concern or issue please contact us.
Steve@americanracingheaders.com
If there is ever a concern or issue please contact us.
Steve@americanracingheaders.com
#10
ARH 2" will fit with steering shaft clearance.
If there is ever a concern or issue please contact us.
Steve@americanracingheaders.com
If there is ever a concern or issue please contact us.
Steve@americanracingheaders.com