WTT 04 Cobra
03-15-2010, 02:31 PM
#1
Advanced
Thread Starter
Member Since: Mar 2010
Posts: 71
Likes: 0
Received 0 Likes
on
0 Posts
WTT 04 Cobra
Like the title says looking to trade my 04 cobra for any c6 vette that is a 6 speed or c5 z06. All modifications were done about 10,xxx miles ago
Pictures of the car are when it was dirty. Sorry for the qaulity done with an iphone.
Or $28,500
Modifications:
5.1L 307 Stroker with custom pistons 8:1 compression for high boost
Billet rods
Stroker Crank
Stock mildly ported heads
2.8h Kenne Bell Supercharger
low boost 20lbs the car made 657rwhp and 633ftlbs on 93 pump gas
Race gas same boost it made over 700rwhp
So full boost and race gas you would see 800+rwhp
Ram twin disc clutch with upgraded ram 900 clutches billet steel flywheel holds 1200hp
Fully built 8.8 Rear end (solid axle swap) Moser 31 spline axles, c clip elims, welded tubes with tube brace bar, eaton posi with tru trac diff full spool and 4.10 gears, stange shocks and struts, bmr upper and lower control arms
front has fully adjustable coil overs
Brake calipers have been shaved to fit 15s
Comes with two sets of wheels 18s for the street and a set of 15s for whatever track or street.
I havent taken it to the track on this set up yet but I'm sure on the 15 in wheels it should run real low 10s.
Transmission is stock they will hold 800whp all day long stock so never touched it.
If you need any more information about the car including pics email me at jmgdaddy116@Yahoo.com or pm and I will get back to you as soon as I can thanks for the interest.
Pictures of the car are when it was dirty. Sorry for the qaulity done with an iphone.
Or $28,500
Modifications:
5.1L 307 Stroker with custom pistons 8:1 compression for high boost
Billet rods
Stroker Crank
Stock mildly ported heads
2.8h Kenne Bell Supercharger
low boost 20lbs the car made 657rwhp and 633ftlbs on 93 pump gas
Race gas same boost it made over 700rwhp
So full boost and race gas you would see 800+rwhp
Ram twin disc clutch with upgraded ram 900 clutches billet steel flywheel holds 1200hp
Fully built 8.8 Rear end (solid axle swap) Moser 31 spline axles, c clip elims, welded tubes with tube brace bar, eaton posi with tru trac diff full spool and 4.10 gears, stange shocks and struts, bmr upper and lower control arms
front has fully adjustable coil overs
Brake calipers have been shaved to fit 15s
Comes with two sets of wheels 18s for the street and a set of 15s for whatever track or street.
I havent taken it to the track on this set up yet but I'm sure on the 15 in wheels it should run real low 10s.
Transmission is stock they will hold 800whp all day long stock so never touched it.
If you need any more information about the car including pics email me at jmgdaddy116@Yahoo.com or pm and I will get back to you as soon as I can thanks for the interest.
Last edited by txvenom; 03-17-2010 at 11:22 AM. Reason: adding pics
03-17-2010, 09:07 AM
#6
Safety Car
Member Since: Aug 2008
Posts: 4,184
Likes: 0
Received 0 Likes
on
0 Posts
03-24-2010, 09:18 AM
#15
Race Director
Quote "looking to trade my 04 cobra for any c6 vette that is a 6 speed or c5 z06." If those Cobras are a dime a dozen then WTH are those Vettes???To the OP- Good luck with the trade! Your car makes some serious power, hope it goes to someone that will use it
06-20-2010, 06:05 PM
#18
Melting Slicks
I went from my 03 stage IV stieg 600hp 515rwhp fully built, viper spec tranny, just $20k in engine and tranny alone, cobra to my * lightly modded *C6 and have NEVER looked back!!! Good Luck!!
