Mike@NewEra

This package is simple yet effective, 2nd time we did this in the last few months, and as usual, we are very happy with the results. I took a few pics of the car, and the dyno results as well.

TOM ZR1

WOW MIKE, those are some good #s cant wait till i put my foot in it !!!!!

Al3x_666

nice to share with us!!

I will need this package too!

WeaponsGradeTorque

Congrats !!

What size are the headers?

Any lower pulley or just 2.6 upper?

05dsom

nice

looks familiar.

RPO_Z06

So what all does this package include?

TOM ZR1

AMR HEADERS 1 3/4 NO LOWER PULLEY, KEEP IN MIND A LOT OF THIS POWER COMES FROM A GOOD TUNE..SEE MIKE AT NEW ERA PERF.

TOM ZR1

i would look up LPE web site and click on the 710 package..it is all layed out there for you to see...good luck to you...

TOM ZR1

Yes, it does look very close. i saw your car last on this forum. your the reason a went out and got new comp grey wheels and new tires for it.
when i get the car wed i will be putting my new wheels on ..just wont be able to drive it, looks like snow is coming again...happy motoring to you TOM...

passons

Looks very nice.

RPO_Z06

I'm familiar with the 710 kit contents, I more referring to what this particular setup had over that to make it net the extra HP vs. what I've seen the 710 do, I suppose the headers and fine tuning are the answer to that question. Very good #'s indeed!

TOM ZR1

Yes,, you are correct sir, headers and a good tune on a dyno

05dsom

$hit, I hope not, I have a track event at the Glen on
May 2-3

ProEFI

Great Job Mike.

05dsom

back from Dubai Mike? I emailed a few weeks back about harness bar and 5 point harness but you were out of the country.

SteveDoten@ARH

Mike, those pics look outstanding sir!! As always, top level work with attention to detail.

I see the Trifecta, Copo, CJ, DragPack poster hanging up, very cool.

TOM ZR1

Got a question for you, after the 710 kit was installed, i notice a steady ticking or clicking sound at a steady speed of say 35 to 45 mph no load on the engine just a steady cruise. if i increase the throttle it stops or slow down it stops. can not duplicate this in the driveway. i think it is from the relief valve opening and closing. like it does not know where it should be..i was wondering if yours has this noise as well ?? thanks for your time,TOM

05dsom

nope, mine is dead quiet -- until i open the exhaust valves..then

double06

Start at - like 540 hp and 520 tq?

WeaponsGradeTorque

as high as 560 rwhp on a dynojet (could be less on a mustang dyno). This is what LPE, Edmunds, Road And Track got on a stock ZR1.

http://www.edmunds.com/car-reviews/t...vette-zr1.html

https://www.google.com/search?q=stoc...%3B1400%3B1082


http://www.lsxtv.com/news/video-corv...laren-mp4-12c/

The Road and Track Video shows a stock ZR1 dyno 559 rwhp, 526 rwtq. I believe these numbers because they were done at Hennessey's place with Factory Reps present. So, no dyno games.