You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join Corvetteforum.com today!
Snake, I can't recall if it was di-noc or 1080, but I'm certain it was 3M. I just happened to have a sign shop near work that also did partial wraps on police/gov't cars & had a big piece of it on hand for $30.
If you do this with the matte black you'll be surprised how durable it is, & how well it matches all the other matte black stock trim. Couple pointers; be sure to leave enough material inside of the cut-outs, corners especially (vent ports, radio hole, etc) so that you can pull it tight enough so that it adheres completely & doesn't release at all.
Lastly, heat & pull the material tightly around/over the holes, for the shifter & drink holder especially, to prevent it from getting air tiny bubbles under it. Otherwise it's pretty straightforward to install this stuff & it's easy to pull the console & re-do certain spots if they're not perfect.