**New Carbon Fiber Rear Diffuser**
#381
Drifting
#382
Guest
Posts: n/a
I have been sending emails with the tracking numbers. Please check your email. Since there were so many orders sending the email was the easiest way to get the info to you. I will have more on Monday also so please be patient as I am on the mfg every day to get the orders out.
#384
Guest
Posts: n/a
I have been sending emails with the tracking numbers. Please check your email. Since there were so many orders sending the email was the easiest way to get the info to you. I will have more on Monday also so please be patient as I am on the mfg every day to get the orders out.
Your pain is my pain too! They tell me three to four weeks....then it turns into six weeks.
Your pain is my pain too! They tell me three to four weeks....then it turns into six weeks.
#385
Burning Brakes
Member Since: Jan 2009
Location: Martin KY
Posts: 938
Likes: 0
Received 5 Likes
on
5 Posts
2015 C6 of Year Finalist
I have been sending emails with the tracking numbers. Please check your email. Since there were so many orders sending the email was the easiest way to get the info to you. I will have more on Monday also so please be patient as I am on the mfg every day to get the orders out.
Your pain is my pain too! They tell me three to four weeks....then it turns into six weeks.
Your pain is my pain too! They tell me three to four weeks....then it turns into six weeks.
Derwin
#386
Guest
Posts: n/a
#392
Racer
Member Since: Oct 2008
Location: Cypress Texas
Posts: 268
Likes: 0
Received 0 Likes
on
0 Posts
Any problems removing/installing the old/new diffuser? I have a BB Fusion exhaust with mild to wild. Just wondering if I would have to remove anything else that might make installation a pain.
Thanks
Thanks
#394
Guest
Posts: n/a
#397
Tech Contributor
Finally got around to installing mine last weekend. (I've had it for over 10 months)
The fit was good except for the passengers side backup light. There was a gap at the top the was a little too big. I glued a black piece of rubber on the inside to make the gap less noticeable.
You would have to bend down pretty far to notice it.
I'll post up a thread this weekend with some photos, both finished and during the process.
The fit was good except for the passengers side backup light. There was a gap at the top the was a little too big. I glued a black piece of rubber on the inside to make the gap less noticeable.
You would have to bend down pretty far to notice it.
I'll post up a thread this weekend with some photos, both finished and during the process.