C5 Tech Corvette Tech/Performance: LS1 Corvette Technical Info, Internal Engine, External Engine, Tech Topics, Basic Tech, Maintenance, How to Remove & Replace
Sponsored by:
Sponsored by:

Help w/DTC codes

Old 02-14-2013, 09:03 AM
  #1  
zeke2u
Racer
Thread Starter
 
zeke2u's Avatar
 
Member Since: Mar 2011
Location: lancaster MA
Posts: 394
Received 56 Likes on 33 Posts

Default Help w/DTC codes

Just picked-up a salvaged '03 Z06 w/25k miles. It was a non-collision total (roof and windshield damage). Only drove it from the carrier truck to my house (300 yards) but seems to run fine - engine sounds great. However, the ABS light and "Service Vehicle Soon" are lit. When I ran the DTC codes, there were quite a few. There was one PCM code: P1571, which I was able to decipher as "Traction Control - desired torque circuit. However, the other codes I need help with:
28 TCS - No comm.
40 BCM 12 codes
BO 432 H
502 H
503 H
507 H
508 H
B 2482 H
2528 H
2578 H
2583 H
2587 H
2592 H
U 1096 H
58 SDM U 1040 H C
A0 LDCM B 2282 H
2284 H
2278 H
1064 H
1016 H
A1 RDCM B 2283 H
2285 H
U 1255 H
1064 H
1016 H
1096 H
A6 SCM B0 851 H
856 H
RFA U 1000 H
1255 H

Any help would be greatly appreciated - and yes, I will soon be buying a service manual!
Old 02-15-2013, 06:31 AM
  #2  
zeke2u
Racer
Thread Starter
 
zeke2u's Avatar
 
Member Since: Mar 2011
Location: lancaster MA
Posts: 394
Received 56 Likes on 33 Posts

Default

Thanks 8Vette7. Ya, I'll erase them all. Most of them aren't current, though, and when I looked at the Chevy vehicle report I noticed that the windshield and floor mats were replaced, under warranty, at ~14k miles. Some of the codes may have been set then - the vehicle only had another 11k miles put on it in the 9 following years. The only thing that really concerns me is the ABS light. Also, I just ordered the service repair manual on eBay, as I am preparing to remove all the trim, headliner, etc. to get the windshield out and repair the roof. Hopefully, weather and state-police inspection permitting, I will be driving it soon....thanks again


Thread Tools
Search this Thread
Quick Reply: Help w/DTC codes



All times are GMT -4. The time now is 07:00 PM.