You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join Corvetteforum.com today!
Bilstein Sports, ~7,000 miles, in great shape. All bushings/washers and nuts present and accounted for. SOLD
Stock rockers with a Comp trunion upgrade. I had 99BlancoSS (former vendor) upgrade these for me and never installed them. It is a complete set of 16, with the bolts. The rocker arms themselves were used when I sent them to him, but they have not been installed since the trunion upgrade. Asking $200 shipped
Trick flow coolant adapters for LSX engines. This came as a set of 4, I used two of them. LS6 engines do not have a rear coolant crossover, they just have plugs. These black fittings take the place of those plugs and allow you to connect a -4AN fitting to them to plumb the rear of the cylinder heads into your cooling system. I am including what is pictured here:
I ran a line from the rear drivers side to the rear passenger side, and connected them with a 1/4" Tee fitting.
I then ran a line from the open spot on the Tee fitting along the heater hoses on the passenger side. I cut the line that goes from the radiator to the front crossover (or throttle body if it isn't bypassed) and added another 1/4" Tee fitting. I replaced the rest of the line that runs to the front crossover/throttle body with 1/4" hose.
You will need several feet of 1/4" hose, and two brass 1/4" Tee fittings to make this work. Asking $45 shipped for the two adapters and two 90 degree -4AN fittings, and some 1/4" clamps. These adapters by themselves are $20 each from summit, you are basically getting the AN fittings for free.
Thanks for looking!
Last edited by Mike94ZLT1; 05-29-2013 at 06:10 PM.