Replacement Air Dams On Sale! **$89.99**
#22
Safety Car
Member Since: Sep 2007
Location: Sunniest city on Earth
Posts: 4,169
Likes: 0
Received 21 Likes
on
20 Posts
Received and installed the metal was bent in at one end (I assume by the postal service), may want to put a note listing as fragile on future shipments so this part that tends to see so much abuse once in place doesn't get off to a bad start before it's even installed
#26
Le Mans Master
Question for you..
Is your center air damn plastic as stiff as the oem plastic? (meaning is it pretty sturdy?).. I already have your LH/RH pieces and they were noticeably more flexable then the oem plastics... I need the center piece to be pretty stiff to help with an air flow issue I have..
I am ready to order the center piece and hardware if you can describe the rigidity of it.
Thanks.
Is your center air damn plastic as stiff as the oem plastic? (meaning is it pretty sturdy?).. I already have your LH/RH pieces and they were noticeably more flexable then the oem plastics... I need the center piece to be pretty stiff to help with an air flow issue I have..
I am ready to order the center piece and hardware if you can describe the rigidity of it.
Thanks.
#27
Former Vendor
Thread Starter
Member Since: Dec 2007
Location: Ft Worth TX
Posts: 22,135
Likes: 0
Received 2 Likes
on
2 Posts
St. Jude Donor '12-'13
Question for you..
Is your center air damn plastic as stiff as the oem plastic? (meaning is it pretty sturdy?).. I already have your LH/RH pieces and they were noticeably more flexable then the oem plastics... I need the center piece to be pretty stiff to help with an air flow issue I have..
I am ready to order the center piece and hardware if you can describe the rigidity of it.
Thanks.
Is your center air damn plastic as stiff as the oem plastic? (meaning is it pretty sturdy?).. I already have your LH/RH pieces and they were noticeably more flexable then the oem plastics... I need the center piece to be pretty stiff to help with an air flow issue I have..
I am ready to order the center piece and hardware if you can describe the rigidity of it.
Thanks.
The center pieces is very rigid though. thx
#31
Drifting
I have a new cradle for my blower. Could I use the factory center piece still? For some reasons, the installer replaces with a bolted on piece that does not spring back from Procharger!