Cartek LS2 built block, 1/2" head stud, main girdle, etc
#1
Drifting
Thread Starter
Member Since: Feb 2007
Location: Cranford NJ
Posts: 1,446
Likes: 0
Received 0 Likes
on
0 Posts
Cartek LS2 built block, 1/2" head stud, main girdle, etc
For sale is my low mileage LS2 block that has had the following work done to it:
Main cap line hone
Tops of main caps milled for fitment of Main girdle
Includes DM Performance main girdle
Includes ARP main studs
Clearancing for 4" stroke
Machining for 1/2" head stud conversion
Includes ARP 1/2" head studs
New cam bearings
Cylinder hone (will be done to your specification)
Pretty much ready to go.
Asking $2200
I also have a set of coated Diamond custom pistons(with rings and wrist pins) for a 4" stroke with a -28cc dish (Brand NEW set, never used - worth over +$1000) that I will sell with the block as a package for $2700. Bore will be finished for those pistons in that case.
This is my own block that I was going to use... just looking to go a different route with the build... the only reason for the sale.
Shipping will be whatever it cost to ship, so per case basis. Pick-up at Cartek can be arranged.
Any questions just contact me at max@cartek.net
Thanks for looking,
Max
Main cap line hone
Tops of main caps milled for fitment of Main girdle
Includes DM Performance main girdle
Includes ARP main studs
Clearancing for 4" stroke
Machining for 1/2" head stud conversion
Includes ARP 1/2" head studs
New cam bearings
Cylinder hone (will be done to your specification)
Pretty much ready to go.
Asking $2200
I also have a set of coated Diamond custom pistons(with rings and wrist pins) for a 4" stroke with a -28cc dish (Brand NEW set, never used - worth over +$1000) that I will sell with the block as a package for $2700. Bore will be finished for those pistons in that case.
This is my own block that I was going to use... just looking to go a different route with the build... the only reason for the sale.
Shipping will be whatever it cost to ship, so per case basis. Pick-up at Cartek can be arranged.
Any questions just contact me at max@cartek.net
Thanks for looking,
Max