FS: C5/Z06 Borla Catback Part #12649 $300 shipped
11-26-2007, 12:36 PM
#1
Racer
Thread Starter
FS: C5/Z06 Borla Catback Part #12649 $275 shipped
$275 shipped. I take paypal to LSInnovations@gmail.com
Selling complete Borla Catback Straight Pipe System for C5 & Z06.
It was on the car about 10-15k miles. Its in nice shape and I just removed it to put the factory catback on to sell car.
I dont have any pictures at the moment as I just took it off and put it back in the box to keep it from getting scratched up. Tips are in nice shape and taped up well in the box to keep them from getting any marks on them. Only requires one weld to attach one side pipe on the installation. Direct bolt on in 30 minutes (very easy to install since they dont have large mufflers in them, plus they are about 10lbs lighter than the factory catback)
This is borlas picture from website of it. (looks just like it)
Selling complete Borla Catback Straight Pipe System for C5 & Z06.
It was on the car about 10-15k miles. Its in nice shape and I just removed it to put the factory catback on to sell car.
I dont have any pictures at the moment as I just took it off and put it back in the box to keep it from getting scratched up. Tips are in nice shape and taped up well in the box to keep them from getting any marks on them. Only requires one weld to attach one side pipe on the installation. Direct bolt on in 30 minutes (very easy to install since they dont have large mufflers in them, plus they are about 10lbs lighter than the factory catback)
This is borlas picture from website of it. (looks just like it)
Last edited by VTESPEED; 11-26-2007 at 06:16 PM.
11-26-2007, 09:38 PM
#6
Burning Brakes
Member Since: Jul 2007
Location: Stillwater OK
Posts: 1,081
Likes: 0
Received 0 Likes
on
0 Posts
I have these on my car. They aren't bad when driving around town. There is some drone when driving down the highway, but I have longtube headers and no cats. I get lots of comments every where I go. Wide open throttle turns heads. 
11-27-2007, 08:36 PM
#12
Former Vendor
Member Since: Mar 2003
Location: Tampa FL
Posts: 18,673
Received 393 Likes
on
286 Posts
St. Jude Donor '07-'08-'09-'10-'11-'12'-'13-'14-'15
It is nasty
I love it
Cajun
11-27-2007, 08:38 PM
#13
Former Vendor
Member Since: Mar 2003
Location: Tampa FL
Posts: 18,673
Received 393 Likes
on
286 Posts
St. Jude Donor '07-'08-'09-'10-'11-'12'-'13-'14-'15
Also I believe that stock catback is 22lbs per side which means these are ALOT lighter than stock. I would guess 5-7lbs per side.
Cajun
Cajun
11-27-2007, 08:56 PM
#15
Drifting
http://www.youtube.com/watch?v=xNxFGh8L9mw
11-27-2007, 09:12 PM
#16
Former Vendor
Member Since: Mar 2003
Location: Tampa FL
Posts: 18,673
Received 393 Likes
on
286 Posts
St. Jude Donor '07-'08-'09-'10-'11-'12'-'13-'14-'15
here's my car with my old set up...no cats! these are the straight pipes
http://www.youtube.com/watch?v=xNxFGh8L9mw
http://www.youtube.com/watch?v=xNxFGh8L9mw
Mine was so damned narly on the dyno that it loosened and popped off two of the mounting bolts after 4 runs.
cAJUN
11-28-2007, 10:39 PM
#17
Burning Brakes
Member Since: Jul 2007
Location: Stillwater OK
Posts: 1,081
Likes: 0
Received 0 Likes
on
0 Posts
12-12-2007, 12:38 AM
#20
Race Director
so I get this catback from vtespeed, and one of the pipes is chopped straight thru, would you say that was as described with the 1 weld to install? not taken apart at the joint with the flare and the band clamp but chopped straight thru ripped with a sawzall. Everybody and their brother has a welder capable of stainless in the garage right?
or am I overreacting.??
or am I overreacting.??