FS: Supercharged 2004 Z06, Torch Red
#1
FS: Supercharged 2004 Z06, Torch Red
For Sale – Supercharged Torch Red 2004 Z06, 27,110 miles, 635 RWHP / 538 RWTQ. I have decided to part with my baby. She is clean with no accidents and only a few paint chips and a little carpet pull away in tunnel section. I am the original owner. Car has been tracked approx 10 times (fully taped each outing). Oil has been changed approximately every 1500 Miles (I know, not necessary, no comments needed). Car being sold to reduce the stable (I also have a C6 Z06) and I no longer drive the car enough to warrant keeping it. Driving the car requires a certain level of constraint as any 635 RWHP car does. But kept in check this car delivers an outstanding experience on each outing.
The car has the following mods:
A&A Forged LS2 402 (12K Miles)
• Mahl Pistons
• Scat Rods
• Eagle Crank
• ARP Bolts/Studs (rods, heads, mains)
• Hellfire Rings
• Edelbrock Heads
• Crane Gold Roller Rockers (1.8)
• Smith Brothers Push Rods
• Comp Cams Cam
• High Output oil pump
LG Long Tube Headers & XPipe (have original manifolds/xpipe)
A&A / Vortech S Trim Centrifugal Supercharger running 9.5 Lbs Boost (13K Miles)
• Larger full width intercooler
• Larger 4” Dongle
• Mondo Blow off valve
• 8 rib pulley
• Boost and Fuel Pod/Gauges
• Innovators West Overdrive 8 rib harmonic balancer
• Cartek Flip Drive
Alky Control Meth Injection (using washer tank)
A&A High Capacity Fuel System (pump, lines, filter, gauges, regulator)
Seatrab Oil cooler with fans (mounted in fender well)
Ron Davis custom radiator ( 2x1.25” rows, Power Steering Cooler)
Dewitt’s Spal Fans and Shroud (radiator)
Turn One Power Steering Pump and Pulley
Textralia 700 clutch and fly wheel
Clutch bleed line
3.46 gears with hardened output shaft
Baer Drilled and Slotted Brake Rotors
LG Brake Backing Plates (for cooling)
DRM Brake Front Brake Ducts
DRM Stainless Steel Pistons (front brakes)
Stainless Steel Brake Lines
Phadt Coil-overs
Phadt Racing Sway Bars
Elite Tunnel Plate
Aftermarket Chrome Wheels
Toyo RA1 Tires
Hurst Shifter
Hardbar Harness Bar & Belt hardware for stock seats
Crow Harness Belts
Full floor and trunk Dynomat
Carpeted Partition
Car located in Southern California. Asking $27,000, no trades. PM me, or call me on 562-243-1923.
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
This is the original dynorun from A&A at 625 RWHP and RWTQ of 568. The car has since dynoed at closer to 650 RWHP. When I locate the sheet I will post it.
By Popular demand i have added a You Tube Video:
The car has the following mods:
A&A Forged LS2 402 (12K Miles)
• Mahl Pistons
• Scat Rods
• Eagle Crank
• ARP Bolts/Studs (rods, heads, mains)
• Hellfire Rings
• Edelbrock Heads
• Crane Gold Roller Rockers (1.8)
• Smith Brothers Push Rods
• Comp Cams Cam
• High Output oil pump
LG Long Tube Headers & XPipe (have original manifolds/xpipe)
A&A / Vortech S Trim Centrifugal Supercharger running 9.5 Lbs Boost (13K Miles)
• Larger full width intercooler
• Larger 4” Dongle
• Mondo Blow off valve
• 8 rib pulley
• Boost and Fuel Pod/Gauges
• Innovators West Overdrive 8 rib harmonic balancer
• Cartek Flip Drive
Alky Control Meth Injection (using washer tank)
A&A High Capacity Fuel System (pump, lines, filter, gauges, regulator)
Seatrab Oil cooler with fans (mounted in fender well)
Ron Davis custom radiator ( 2x1.25” rows, Power Steering Cooler)
Dewitt’s Spal Fans and Shroud (radiator)
Turn One Power Steering Pump and Pulley
Textralia 700 clutch and fly wheel
Clutch bleed line
3.46 gears with hardened output shaft
Baer Drilled and Slotted Brake Rotors
LG Brake Backing Plates (for cooling)
DRM Brake Front Brake Ducts
DRM Stainless Steel Pistons (front brakes)
Stainless Steel Brake Lines
Phadt Coil-overs
Phadt Racing Sway Bars
Elite Tunnel Plate
Aftermarket Chrome Wheels
Toyo RA1 Tires
Hurst Shifter
Hardbar Harness Bar & Belt hardware for stock seats
Crow Harness Belts
Full floor and trunk Dynomat
Carpeted Partition
Car located in Southern California. Asking $27,000, no trades. PM me, or call me on 562-243-1923.
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
This is the original dynorun from A&A at 625 RWHP and RWTQ of 568. The car has since dynoed at closer to 650 RWHP. When I locate the sheet I will post it.
By Popular demand i have added a You Tube Video:
Last edited by Badd Vett; 06-16-2013 at 09:19 PM. Reason: Added Dyno Sheet
#5
Vettethreat, the car has an LG X Pipe, then stock Titanium mufflers from there. I have not heard anything that I thought sounded much better so I left the original pipes on.
#10
Le Mans Master
Member Since: Dec 2003
Location: Phoenix Arizona
Posts: 5,864
Likes: 0
Received 16 Likes
on
13 Posts
Is there any rational reason why this car isn't sold already?
Low, low miles, forged motor, AA supercharged, coilovers, etc etc etc. - this car is easily worth a minimum of $5K more than he's asking.
Somebody is going to get a giant killer for very little money -
Low, low miles, forged motor, AA supercharged, coilovers, etc etc etc. - this car is easily worth a minimum of $5K more than he's asking.
Somebody is going to get a giant killer for very little money -
#11
Digital Disaster, thanks for the comments. As for "rational", i don't know that it applies to how much i have invested in the car.
BTW, I will post the dyno sheet tomorrow. I am also working to do a video/sound strip.
BTW, I will post the dyno sheet tomorrow. I am also working to do a video/sound strip.
#12
Le Mans Master
Member Since: Dec 2003
Location: Phoenix Arizona
Posts: 5,864
Likes: 0
Received 16 Likes
on
13 Posts
I looked for months for an affordable low mile forged SC'd Z06 like this with no success before I bought my present car.
A video will seal the deal quickly, IMHO. Don't take a penny less!
#19
Le Mans Master
I have a close friend in Corona, CA that is a certified GM mechanic. Can I have him come over and look over the car and advise me, so that I may make you an offer?