Is 'mrcrowley' still around...have a question about his cage tied into his c beam
07-07-2014, 07:12 PM
#1
Race Director
Thread Starter
Is 'mrcrowley' still around...have a question about his cage tied into his c beam
Hi
I was diggng thru some posts, and i found a user 'mr crowley, posted some pictures of a rollcage with a 'snubber plate' bolted thru his cbeam /diff rear mount.
This was back in 2006!
I believe he was a zr1 guy.
I thought this was very ingenious and wanted to ask him how it worked out.
he also had solid motor mounts and solid batwing bushings.
Does anyone know anything about this setup?
I was diggng thru some posts, and i found a user 'mr crowley, posted some pictures of a rollcage with a 'snubber plate' bolted thru his cbeam /diff rear mount.
This was back in 2006!
I believe he was a zr1 guy.
I thought this was very ingenious and wanted to ask him how it worked out.
he also had solid motor mounts and solid batwing bushings.
Does anyone know anything about this setup?
07-08-2014, 04:06 PM
#3
Team Owner
Member Since: Oct 2004
Location: altered state
Posts: 81,242
Received 3,043 Likes
on
2,602 Posts
St. Jude Donor '05
Hopefully still around he was a big help to me back then seemed like a real nice guy. Got run off the board yrs ago by a few forum favorites
Theres room for more than 1 or two Z tuners on this planet imo
Anyone who has good knowledge of these cars is an asset if youre a Z owner.
Theres room for more than 1 or two Z tuners on this planet imo
Anyone who has good knowledge of these cars is an asset if youre a Z owner.
07-08-2014, 05:18 PM
#5
07-08-2014, 06:33 PM
#6
Burning Brakes
As others stated give Mike a call I'm sure he will help you out, that is the correct number for him that zr-1 guy posted. Also GS977 here on the forum is running the same set up.
-Daniel
-Daniel