Anyone have a J-38463 damper installer? :)
#1
Race Director
Thread Starter
Member Since: Oct 2001
Location: Canton GA
Posts: 12,742
Received 88 Likes
on
34 Posts
Cruise-In III Veteran
Cruise-In IV Veteran
Cruise-In VI Veteran
St. Jude Donor '03-'05-'06-'10-'11-'12
Anyone have a J-38463 damper installer? :)
Yeah, I know, I haven't been around in a while, and when I do stick my head back in here, I'm asking for something. Well, for the last couple of years, my Z has been off the road as I've been procrastinating about putting the engine back together. Well, I've gotten a lot done but I'm stuck at the harmonic balancer, need the tool to get that thing on without damaging anything.
Side note: Who in their right mind would make a M16 x1.0 threaded anything let alone a crank bolt?! Yeah, sure, I thought I would just go out and get some threaded rod and make up my own after searching all over for a universal installer.... but NOooooo! Pure unobtanium!
Obviously I'll pay shipping and insurance, I wouldn't need it more than a couple of days. Just think, you'd be helping put another Z back on the road!
Side note: Who in their right mind would make a M16 x1.0 threaded anything let alone a crank bolt?! Yeah, sure, I thought I would just go out and get some threaded rod and make up my own after searching all over for a universal installer.... but NOooooo! Pure unobtanium!
Obviously I'll pay shipping and insurance, I wouldn't need it more than a couple of days. Just think, you'd be helping put another Z back on the road!
#2
Le Mans Master
Member Since: Jan 2000
Location: Georgetown TX
Posts: 8,448
Received 1,872 Likes
on
1,086 Posts
C5 of Year Finalist (appearance mods) 2019
Shawn,I noticed you live in Georgia. Are you close to SGC?
#4
Tech Contributor
Harmonic Balancer Installer for LT5
Made my own harmonic Balancer Installer...the second installer.....I forgot what I made that one for
Just bought an extra USED Harmonic Balancer Bolt from Jerry Harmonic Balancer Bolt
Welded 1/2 inch threaded rod to end of Harmonic Balancer Bolt
The key is to weld the threaded rod on center of the bolt and ON CENTER LINE of the bolt.
Just bought an extra USED Harmonic Balancer Bolt from Jerry Harmonic Balancer Bolt
Welded 1/2 inch threaded rod to end of Harmonic Balancer Bolt
The key is to weld the threaded rod on center of the bolt and ON CENTER LINE of the bolt.
Last edited by Dynomite; 03-18-2014 at 10:28 PM.
#5
Race Director
Thread Starter
Member Since: Oct 2001
Location: Canton GA
Posts: 12,742
Received 88 Likes
on
34 Posts
Cruise-In III Veteran
Cruise-In IV Veteran
Cruise-In VI Veteran
St. Jude Donor '03-'05-'06-'10-'11-'12
Nice job... but, I'm not a welder
It looks like White has one for rent, I'll only need it for a day, I'll bite the bullet.
It looks like White has one for rent, I'll only need it for a day, I'll bite the bullet.