WTB: ZR1 ram air intake scoop for front license plate
#1
Intermediate
Thread Starter
Member Since: Jul 2013
Location: New Jersey
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
WTB: ZR1 ram air intake scoop for front license plate
Would like to buy the front license plate scoop out of a ZR1 or aftermarket if someone has one available.
Thanks,
Gene K.
Thanks,
Gene K.
#2
Le Mans Master
I am currently sourcing a Vacuum forming vendor to reproduce these. I purchased the rights to the AO Engineering Forced Air System last year.
I'll keep everyone posted once the air inlet is produced.
I'll keep everyone posted once the air inlet is produced.
#5
I am going to need a few.
Last edited by cvette98pacecar; 11-20-2013 at 06:59 PM.
#7
Le Mans Master
#8
Tech Contributor
Front Licesense Plate Requirements
More Scoop
Maybe I am all wet here but if you cannot eliminate the front license plate.....seems could be an issue for Scoop installation
Or am I confused about the design of the scoop
Texas Law says you have to have a front License Plate but the law tripped up somehow and will not be enforced
Maybe I am all wet here but if you cannot eliminate the front license plate.....seems could be an issue for Scoop installation
Or am I confused about the design of the scoop
Texas Law says you have to have a front License Plate but the law tripped up somehow and will not be enforced
Last edited by Dynomite; 11-24-2013 at 09:36 AM.
#9
Drifting
When I lived in Colorado and Texas, they required front plates, but it was one of the laws that wasn't really enforced. Unless you were already pulled over and the cop wanted to tack on an extra fee.
Thankfully, I've been in GA and now NM.....no front plate and the front bumper looks better for it.
VetteDaddy,
Good on you for getting them back into production!
Chris
Thankfully, I've been in GA and now NM.....no front plate and the front bumper looks better for it.
VetteDaddy,
Good on you for getting them back into production!
Chris
#11
NCM Lifetime # 982
I'm on LI too. Haven't used a front plate on any of my Corvette's. Never got a ticket either. But don't frequent OBI-Captree scene.
The Police have nothing better to do ? They have red light camera's and bust chops for no front plate.
Crime is going out of sight , heroin , oxy addiction etc. This area is going down hill fast.
#12
Intermediate
Member Since: Jul 2010
Location: Lincoln Nebraska
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
New law passed in Nebraska effective January 1, 2013. With the purchase of a Special Interest license plate at an additional cost of $50, only the rear plate is required.
Dale Zimmerman
Lincoln, NE
Dale Zimmerman
Lincoln, NE
#13
Drifting
At least on the C5 and earlier, there's a reasonable place to put the plate without ruining the car. On the C6, you have to drill holes in the bumper to mount it.
Time to move to a place where you can buy Vette Daddy's part.....
Chris
#14
NCM Lifetime # 982
#15
I personally think I should get a discount for being shot at while on active duty.
#16
Shoot, I paid 3 dollars for my DV plates on the vette that is the only licensing fee I ever had to pay even when I purchased it! They take good care of us down here.
#17
Intermediate
Thread Starter
Member Since: Jul 2013
Location: New Jersey
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
N.J. is alright, had my '94 for about 8-9yrs now and never installed the front plate. It's on the side of the drivers seat if asked about it, would plead insanity as to how to install. Could probably throw it on the dash board before the officer pulled me over. I have driven through a couple check points, I guess the F.O.P. badge helps although I donate every year, so it still costs me. I guess some police are just not Corvette fans, probably mustang owners.
#18
Looks really good anyway with the cut outs in the front..
Thnx