ZR1 Parts for Sale
#1
ZR1 Parts for Sale
My ad seems to have gone m.i.a., so here it is again. For those that have responded, I will have shipping info tomorrow.
Pictures are posted as follows:
http://s1094.photobucket.com/albums/...ale/?start=all
The cam cover was bought to be mounted on a piece of oak to go to shows with for signatures, which I never did.
These are from my 1991 ZR1
I am in Patchogue NY, 11772
####
The car is gone but these are still here and I need the room.
NEW SS Geoff Jeal Headers, complete & unassembled, sold
NEW Hurst / B&M Short throw Shifter, Part #: 3915084, $120, sold
NEW Pair of Fuel Injectors, one each primary & secondary
17069647, Injector, Primary A/C Delco, $120.00
17069648, Injector, Secondary A/C Delco, $ 115.00
New A/C Switch, GM # 14078970, A/C Compressor Coolant Temperature,
fits 1990 - 1993 Model, $30
New BURU spark plugs, set of 8 , Beru Silverstone S3Fs. These have silver electrodes. Silver is both the best thermal and best electrical conductor. In addition, these particular plugs are non-resistor type., $55.00
New Plenum Gaskets, 2 pcs, 1 set, $25.00, sold
New GM Front License plate Bumper Blank, fits 1991 -1996, $40.00, sold
USED
Full set of injectors ( 16 ) on fuel rails with cross overs & fuel regulator, $350.00 or BEST OFFER
4 Original "Turbine" Sawblade Rims with all 4 Wheel Sensors & Original Gator Backs still mounted, fronts are good, backs are junk ( haha ). I would not use either. $400.00, sold
Intake Plenum, $200.00, sold
The below used parts were all removed with 25 k miles on the car during engine upgrade to 368.
All work fine, they were just upgraded or replaced during the 368 build
Original Crank, $400
Original pistons on rods, complete set of factory rods, pistons, pins, rings & SLEEVES ...$200.00, sold
Original ZR1 plug wires, $250.00
Original Water pump, $75.00
Original Starter, 100.00
Original Coil Pack, $75.00, sold
Original Header cats, left & right, $250.00
Original Exhaust, upgraded to Borla, $50.00
Original Left & Right coolant pipes, $50.00, sold
Original Radiator Dust & air shield seal, used between radiator & shroud, $10.00
Original A frame fender hard plastic molded "dust" seals, left & right, $20.00
Also found a computer harness cover, $15, pending
sun block for the windshield, offer + ship
Rear gas fill insert ( the black inset piece that the gas filler door mounts to ). It needs to be touched up or re finished, but it is not damaged. offer + ship
Not shown is a custom set of tire covers which protect the car cover from tire dirt & gloss. They are black vinyl, pictures up., I had these custom made for over $100, Best offer, ........pending
Thanks, Charlie
Pictures are posted as follows:
http://s1094.photobucket.com/albums/...ale/?start=all
The cam cover was bought to be mounted on a piece of oak to go to shows with for signatures, which I never did.
These are from my 1991 ZR1
I am in Patchogue NY, 11772
####
The car is gone but these are still here and I need the room.
NEW SS Geoff Jeal Headers, complete & unassembled, sold
NEW Hurst / B&M Short throw Shifter, Part #: 3915084, $120, sold
NEW Pair of Fuel Injectors, one each primary & secondary
17069647, Injector, Primary A/C Delco, $120.00
17069648, Injector, Secondary A/C Delco, $ 115.00
New A/C Switch, GM # 14078970, A/C Compressor Coolant Temperature,
fits 1990 - 1993 Model, $30
New BURU spark plugs, set of 8 , Beru Silverstone S3Fs. These have silver electrodes. Silver is both the best thermal and best electrical conductor. In addition, these particular plugs are non-resistor type., $55.00
New Plenum Gaskets, 2 pcs, 1 set, $25.00, sold
New GM Front License plate Bumper Blank, fits 1991 -1996, $40.00, sold
USED
Full set of injectors ( 16 ) on fuel rails with cross overs & fuel regulator, $350.00 or BEST OFFER
4 Original "Turbine" Sawblade Rims with all 4 Wheel Sensors & Original Gator Backs still mounted, fronts are good, backs are junk ( haha ). I would not use either. $400.00, sold
Intake Plenum, $200.00, sold
The below used parts were all removed with 25 k miles on the car during engine upgrade to 368.
All work fine, they were just upgraded or replaced during the 368 build
Original Crank, $400
Original pistons on rods, complete set of factory rods, pistons, pins, rings & SLEEVES ...$200.00, sold
Original ZR1 plug wires, $250.00
Original Water pump, $75.00
Original Starter, 100.00
Original Coil Pack, $75.00, sold
Original Header cats, left & right, $250.00
Original Exhaust, upgraded to Borla, $50.00
Original Left & Right coolant pipes, $50.00, sold
Original Radiator Dust & air shield seal, used between radiator & shroud, $10.00
Original A frame fender hard plastic molded "dust" seals, left & right, $20.00
Also found a computer harness cover, $15, pending
sun block for the windshield, offer + ship
Rear gas fill insert ( the black inset piece that the gas filler door mounts to ). It needs to be touched up or re finished, but it is not damaged. offer + ship
Not shown is a custom set of tire covers which protect the car cover from tire dirt & gloss. They are black vinyl, pictures up., I had these custom made for over $100, Best offer, ........pending
Thanks, Charlie
Last edited by 368LT5; 01-27-2011 at 06:35 PM.
#3
Drifting
Member Since: Jun 2007
Location: Prather, California -1990 ZR-1 White/Flame Red- -SOLD!!-
Posts: 1,261
Likes: 0
Received 2 Likes
on
2 Posts
Consider me first in line for the following:
-Original pistons on rods, complete set of factory rods, pistons, pins, rings & SLEEVES ...$200.00
Also interested in the computer harness cover depending on what you want for it.
What year ZR-1 are these parts from? Also, where are you located?
...
-Original pistons on rods, complete set of factory rods, pistons, pins, rings & SLEEVES ...$200.00
Also interested in the computer harness cover depending on what you want for it.
What year ZR-1 are these parts from? Also, where are you located?
...
Last edited by bdw18_123; 01-24-2011 at 06:51 PM.
#4
#6
Race Director
#7
charlie I would be interested in the front license plate blank and the plenum.
Kevin@glescoelectric.com
Kevin@glescoelectric.com
#9
Intermediate
Member Since: Apr 2010
Location: Sedalia MO
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
I am interested in the wheels.
I had pm'd you last time on then. Still interested if you and Bernd do not make a deal.
Thanks!
Kevin
PS: Tried to PM you but would not go through.
I had pm'd you last time on then. Still interested if you and Bernd do not make a deal.
Thanks!
Kevin
PS: Tried to PM you but would not go through.
#10
charlie I would be interested in the front license plate blank and the plenum.
Kevin@glescoelectric.com
Kevin@glescoelectric.com
Let me know how to send you payment
Kevin