Putting Coolant back in????

[FULLPWR]

Whats the best way to put coolant in after plenum installed?
getting ready to finish it up.

[willie mac]

what i do is leave one of the hoses to the throttle body off then slowly pour in the liquid should take about a gallon and a half (if you drained the rad before).it will fill then walk away for a couple of min. fill it again .Put the rad cap back on, fill the over flow tank all the way up . Go for a 15 min drive. Park it ck the over flow proably bwill be ok. if not fill to the cool line . all should be good.

[willie mac]

OPPS put the t-body coolant line back on before you put the cap back on (sorry) I have C.R.S.

[Crabs]

Pour coolant in until it's about 1/2 inch from full.
Leave cap off and start the engine, let run until at operating temperature.
Add coolant as necessary.
Put the cap back on, check it after driving around the block.

You are using GREEN, right?

TomC
'90ZR1 #792

[FULLPWR]

Originally Posted by Crabs

Pour coolant in until it's about 1/2 inch from full.
Leave cap off and start the engine, let run until at operating temperature.
Add coolant as necessary.
Put the cap back on, check it after driving around the block.

You are using GREEN, right?

TomC
'90ZR1 #792

Thanks Crabs!!

Green???? You know all we have in houston is crude oil BLACK Coolant

Almost there going to see if she LIVES

[FULLPWR]

Originally Posted by willie mac

OPPS put the t-body coolant line back on before you put the cap back on (sorry) I have C.R.S.

Thanks Willie Mac


Luis

[Crabs]

Originally Posted by FULLPWR

Thanks Crabs!!

Green???? You know all we have in houston is crude oil BLACK Coolant

As long as it isn't "Rot Your HeadGasket Red" you'll be fine.


Good luck!!!!!

TomC
'90ZR1 #792

[kmoudy]

:YES!! coolant is good...that is all