Delrin Headlight Bushing sizes
#1
Advanced
Thread Starter
Delrin Headlight Bushing sizes
Hey all,
Just wondering if anyone has any of the delrin bushings for repairing the headlights they could measure up for me, I live in Canada and its really expensive to have these shipped over from USA.
I can get a piece of delrin and machine it down, I just need the correct dimensions for it.
Any help would be appreciated.. I have read a few older posts and got mixed sizes, anywhere from 7/16" to roughly 1/2".. What is the bore size and the O.D? and.. its for an '88
Tony
they look like this..
Just wondering if anyone has any of the delrin bushings for repairing the headlights they could measure up for me, I live in Canada and its really expensive to have these shipped over from USA.
I can get a piece of delrin and machine it down, I just need the correct dimensions for it.
Any help would be appreciated.. I have read a few older posts and got mixed sizes, anywhere from 7/16" to roughly 1/2".. What is the bore size and the O.D? and.. its for an '88
Tony
they look like this..
Last edited by jimgiggles; 04-19-2011 at 01:07 PM.
#2
Racer
I ordered some from ebay very cheap (into canada). Still in a package and can measure them, but they are not hollow, not sure we're talking the same part? These are the 3 plastic pucks in the headlight drive that break down and stop the up/down?
#4
Drifting
mine were .437 in dia. and .455 long.
they do not need a hole in them.
glad to see another person with some machining knowledge on here.
they do not need a hole in them.
glad to see another person with some machining knowledge on here.
Last edited by tblt44; 04-19-2011 at 06:16 PM.
#9
Drifting
#10
Race Director