Pic Request...
#5
Racer
Thread Starter
i did an lt-1 manifold conversion, the thing pulls like a beast but lately i've been getting all these crazy error codes and the wiring harness is shot - cracked, melted all over the place. it was bad when i got the car, but it's at the point where i can't even properly diagnose the codes. i just want to drive the car and enjoy it
Last edited by DrEvil11417; 08-05-2007 at 02:52 AM.
#6
Burning Brakes
Member Since: Sep 2006
Location: Spring Grove Illinois
Posts: 1,142
Likes: 0
Received 0 Likes
on
0 Posts
Here It Comes
Welllllll....I have had nothing but problems with "Betty" when she was TPI... Didnt drive it for almost a year except ( on the back of a flatbed)back and forth to so called shops..Lots of time spent here asking and fixing and asking somemore...Throwing Money at problems that wernt going away...Finally being old skool my ownself (besides being gangsta)..I went back to what I knew...I built a pretty quick engine and had no problems...none I can't handle that is...Now some will say thats going backwards some say it's a waste of dollars..That's their opinion and there intitled to it...Theres nothing wrong with TPI..TBI..or any other type of injection systems...This is what I wanted to do and it works for me..Now I can go on to other Mods
#8
Racer
Thread Starter
#11
Instructor
Member Since: Jul 2007
Location: Toronto Ontario
Posts: 174
Likes: 0
Received 0 Likes
on
0 Posts
I can send u a video of a carb setup. 84 vette with 406 sbc, megajolt ignition (ford EDIS8 ignition with controller), Demon 650, Edelbroke Vic Jun intake, GMPP Fastburn heads, Hooker headers. We threw out all the emissions and wiring harness, used an aftermarket braket for a Saginau steering pump, aftermarket bracket for Si alternator, homemade bracket for timing sensor ( timing wheel is attached to front of crank pulley). Just post your e-mail and I'll send you the vid.
#18
Race Director