mid america LT1 style tips

anesthes · 03-31-2007, 10:43 AM

These were $49 + shipping. quality is lame in regards to thickness, they were stupid hard to weld without blowing holes. I welded 'em on the inside where the metal is double folded/stamped. I'll probably remove the bolts today and hope the welds hold.

What do you guys think?

http://members.cisdi.com/~anesthes/p...paint/tips.jpg
http://members.cisdi.com/~anesthes/p...aint/tips2.jpg

-- Joe

LannyL81 · 03-31-2007, 05:03 PM

If you want some original ones...I just tossed out two LT1 mufflers into the trash can. I could cut the tips off...and send them to you for the cost of shipping them.

LannyL81

anesthes · 03-31-2007, 08:25 PM

Quote:

Originally Posted by LannyL81

If you want some original ones...I just tossed out two LT1 mufflers into the trash can. I could cut the tips off...and send them to you for the cost of shipping them.

LannyL81

wish I knew. I woulda probably bought the mufflers off you. are they single in or dual in? my muffler is dual out.

-- Joe

LannyL81 · 03-31-2007, 10:48 PM

I still have the mufflers...they are sitting in the trash can.
They are stock ''95 LT1 mufflers...single in...single out.

If you want the mufflers...you can have them.

Later,
LannyL81

Bubba91 · 04-02-2007, 12:57 AM

I don't like it, but nice try.
I do like the original LT1 tips.
If I were you I'd take the ones that were offered to you, by Lanny.
Good Luck

anesthes · 04-02-2007, 07:34 AM

Quote:

Originally Posted by LannyL81

I still have the mufflers...they are sitting in the trash can.
They are stock ''95 LT1 mufflers...single in...single out.

If you want the mufflers...you can have them.

Later,
LannyL81

Are the inlets cut off or they still usable? If they would bolt right on I'd be very interested. What's shipping to 01841? Can I get you to snap a pic?

Thanks!

-- Joe

Kool88vette · 04-02-2007, 11:04 AM

You need to toss them. Sorry, but you need to get some good tips. The tips should sit higher too.

enventr · 04-02-2007, 11:44 AM

Get the tips and mufflers from LanniL81-a great deal

coupeguy2001 · 04-02-2007, 01:47 PM

definitely have that poser/amateur look. get the ones from LannieL81
and raise them up a half inch

pr1mu5 · 04-02-2007, 04:31 PM

Sorry ...

LannyL81 · 04-02-2007, 11:21 PM

Quote:

Originally Posted by anesthes

Are the inlets cut off or they still usable? If they would bolt right on I'd be very interested. What's shipping to 01841? Can I get you to snap a pic?

Thanks!

-- Joe

Joe,
Let me get a couple of pictures and send them to you. Send me a PM with your email address.

LannyL81

anesthes · 04-17-2007, 12:48 PM

This better??

http://members.cisdi.com/~anesthes/p...shed/rear3.JPG

-- Joe