WTB: WTB: Lower intake manifold/TPI old style
#1
Instructor
Thread Starter
WTB: Lower intake manifold/TPI old style
I got a TPI setup recently but need the lower intake plenum for the older perimeter bolt style heads (I think that would be 85-86). I'd trade the newer style if that's an option. Thanks, George
#2
Burning Brakes
https://www.corvetteforum.com/forums...0066013-a.html
Ed
#5
Instructor
Thread Starter
#7
Pro
I've got the one I took off of my 85 that I'd be willing to let go. It's dirty bit I can clean it up.
(I've actually got the entire intake minus the throttle body and fuel rails sitting in a box.)
Price for the base is $25 plus actual shipping cost.
Last edited by Sabre34; 07-15-2023 at 01:25 PM.
#8
Pro
#9
Instructor
Thread Starter
#10
Pro
Have a complete 86 engine, will sell the entire tpi setup. Has cold start injector in place still. Just an FYI, the Corvette tpi were straight bolt pattern through 1991, but the cold start injector was deleted on the later units.
I actually have a complete 1986 l98, as well as a complete 1991 l98 engine. Not willing to part out the tpi, that is to say.. if you want the base you're buying the runners, plenum and throttle body with it.. complete tpi intake with fuel rails etc
I actually have a complete 1986 l98, as well as a complete 1991 l98 engine. Not willing to part out the tpi, that is to say.. if you want the base you're buying the runners, plenum and throttle body with it.. complete tpi intake with fuel rails etc